Rated 3.5 out of 5 by 19
Rated 5.0 out of 5.0 by SSinNM Well Built Gauge
Needed a pressure guage that went to 15 PSI for a "one man" brake bleeding setup I was building. This gauge was the only one I could find that could accurately show the low pressure that I needed.
Good quality construction and very accurate.
March 5, 2013
Rated 1.0 out of 5.0 by mamboyoyo Useless....the guage leaks
I took a chance and bought this even though a few other reviews stated that the guage leaked. I was hoping I would get lucky and get a good one like a few of the positive reviewers. I wasn't lucky, and wasted some time trouble shooting my system before testing the gauge on a closed pipe and found it leaking. I immersed it in a bucket and it was bubbling from the face of the gauge. Buyer beware.
January 12, 2016
Rated 1.0 out of 5.0 by MaintenanceTech Leaks at gauge and air chuck
After installing 100 feet of 1/2 copper lines for two propane heaters, I placed this gauge on, and charged it to 15 lbs. I kept getting a slow leak indication. After almost an hour checking all my fittings and connections, I decided to check the gauge itself. Leaky gauge was the culprit. Cheaply made in China. Spend the 50 bucks and get a good a good one.
October 19, 2015
Rated 4.0 out of 5.0 by 14DIY Reliable Product
Everything seemed to function as was expected. My only issue was the condition with which I received the product. Mine had the clear lens partially popped out. I could not get it to snap back in. It doesn't look to effect the functionality. But, in time, I suspect that it will gather dust/dirt and have issues. Yet, due to the relatively low cost, it's not worth the time/effort to return. I needed the product for a specific issue and it worked just fine. Again, I'm just rating it as I did because of the quality and/or condition I received it in.
December 17, 2014
Rated 4.0 out of 5.0 by deb good product
it worked fine it was required gauge by county it was easy to use
August 4, 2015
Rated 3.0 out of 5.0 by Kyle Garbage
I bought 2, both leaked at the nipple. Tried teflon and goop to hold the air in at the air inlet. Good enough for a 15 minute hold.
March 29, 2015
Rated 5.0 out of 5.0 by N1skipper danco gauge
Used this gage to find leakes out on a job sight. Worked great. Even shut the gas guy down that kept saying there was a leak. Great tool to have. Wish there was an inch pound gage I could by that was like the one thy use. Can you do that Home Depot ?
January 8, 2015
Rated 1.0 out of 5.0 by Sarge Bad product
Will return for refund. System would not hold pressure. After much wasted time and labor, discovered that the leak was in the gauge itself. After the last pressure check, the gauge stuck at 11 pounds. Must be defective.
January 6, 2015