Rated 3.0 out of 5 by 42
Rated 1.0 out of 5.0 by mike BIG design flaw with this saw!!!
I nave two other older flush cut saws in my tool box- both are dull and needed replacing- I found this dewalt flush cut at home depot- it was the ONLY brand this store carried. the biggest issue I have with this saw is with the teeth that don't extend to the very end of the saw- for some silly reason, dewalt decided to stop the teeth about 1/8" from the end- and instead, made a smooth edge- this prevents you from being able to cut out a section of casing or trim without passing the saw completely through- this is an obstacle for example when trying to cut casing in one room, where the floor in the next room is above the height of the new floor, and the saw hits the taller floor on the other side- now you have to chisel out the remaining piece because the teeth didn't go to the end of the saw!
May 24, 2016
Rated 4.0 out of 5.0 by DW01 Not bad.
Blade seems to loosen a bit too often during use, but works well enough.
August 23, 2016
Rated 1.0 out of 5.0 by DIYer Saw not up to the task
Purchased the saw to cut the bottom of trim and jambs to accommodate wood flooring. Saw blade is quite flimsy for this work. After a few cuts the blade snapped at the handle. Would not recommend this saw for this type of work.
July 29, 2016
Rated 5.0 out of 5.0 by kathy Flush Cut Pull Saw
DIY project......cutting down a butcher block counter top to screw from inside the drawers of an old dresser which I'm converting into a kitchen island! (my older counter tops are butcher block formica) I'd tried a hand saw and a hacksaw, but too rough and too thick. This cut pull saw worked perfectly. Couldn't get over the thinness of it and its flexibility! Appreciated the two-sidedness of the saw as well. The salesperson at Wentzville Home Depot knew his saws and suggested this one. It gave me a smooth end with no rough edges on the upper and lower edges (I also taped both sides of my cutting seam) and so far I haven't had to do anymore to the counter top except screw it securely to the dresser top. Soooo nice in my kitchen that had very little working space before I did this DIY project. I'd already painted the dresser and put some fat "feet" on it, lined the drawers and put new knobs on the drawers.
February 10, 2016
Rated 4.0 out of 5.0 by Chip Cuts ok
Cutsok, nice and flexable. Teeth cut into my project which didn't make me happy, but it got the job done.
August 9, 2016
Rated 1.0 out of 5.0 by katt178 This thing sucks
The blade is so flimsy, it bends right away once you start using it. This was useless to me, I ended up using a hacksaw with much better results.
July 15, 2016
Rated 5.0 out of 5.0 by popgoesweasel Right tool for the job
I was replacing carpet with laminate and needed to cut off the bottom of some door frames. This tool is perfect for that job
June 13, 2016
Rated 1.0 out of 5.0 by MAHByTheSea Very disappointed
This was exactly what I was looking for to cut Kreg paint grade plugs. I got through 2 of the plugs and on the third plug the blade snapped at the handle. I was going pretty slow and not bending the blade excessively. Too bad, it was making quick work of the plugs when it broke.
May 4, 2016