Rated 4.1 out of 5 by 20
Rated 3.0 out of 5.0 by Gary check "T" width
I purchased this product and tried installing. It was very tight fitting in the slot. After trying for awhile I double check my old seal which was around 1/4". This product was close to 3/8". It is not marked on the package so make sure you check the T width before buying.
April 2, 2016
Rated 5.0 out of 5.0 by Mayerite Very easy to install
Was harder to get the old one out then to install the new one. The strip has about six inches extra so it can be installed tension free. I'm not impressed often but this one worked for me. Of course, I won't know how long it will last for some time yet.
February 10, 2016
Rated 5.0 out of 5.0 by Brad Easy to install
As advertised and easy to install. No issues. Buy.
January 26, 2016
Rated 3.0 out of 5.0 by bish garage door bottom seal
please let your customers know that not all garage door bottom rails are made to fit your T shaped vinyl replacement weather seal, some are 3/8 triangle like on my stanly door, so, if anyone has a problem with inserting seal, that is probably the reason. i have been there!........ t
December 1, 2015
Rated 4.0 out of 5.0 by RonB Bottom seal
This product worked well. Filled the gaps between the garage door and the concrete
May 21, 2014
Rated 5.0 out of 5.0 by SandyT Easy Replacement
These are easy replacement garage door seals. Bought this for our garage door and it fits perfect.
December 20, 2014
Rated 4.0 out of 5.0 by MrWizard Not quite the correct size for the door but....
The seal is fine. The problem was that it was not exactly the one needed for the door. (The ends of the seal were too wide for the slot into which they needed to slide.) With a little trimming and a lot of soap solution it worked. Next time I'll know to measure the width of the channel and make sure it matches the seal's.
September 24, 2014
Rated 4.0 out of 5.0 by RWMDIY Works Great
Easy to install. It does help to have someone feed the seal into the track as you pull it down. Ends of track are usually bent over holding old seal in place. Use a screw driver and a hammer to straighten before trying to remove old seal.
October 21, 2014