Rated 4.6 out of 5 by 118
Rated 5.0 out of 5.0 by Verified Reviewer Add A Pro
directions ok . like it because u can have multiable doors on it
October 11, 2016
Rated 5.0 out of 5.0 by Rhm Super easy to program and install
I have a genie garage door opener and decided to finally break down and get the numeric keypad. I was hesitant because I was concerned about physically installing it. I had programmed a new remote and knew that genie products were pretty easy to program so that wasn't my concern. After speaking with someone and them telling me it's just a couple of holes to drill I decided to purchase it. Like I was informed... it was THAT easy to do. The programming took just a few minutes. I was able to program two garage doors to the one remote. I also did the same PIN for both doors. From my understanding, it sounded like you could program two different PINs for each door if you wanted. You also can set up a temporary PIN. Your PIN can be from 4-8 digits. Another thing I did was spray paint the outside cover so it matched my frame to my garage door. That was simple as well.. I was able to pull the door off easily and re-install it and I just used some spray paint I found and it turned out really well. All in all... very simple project that's already come in handy. It comes with the screws you need to install it.. you just need the proper sized drill bit.
October 5, 2016
Rated 5.0 out of 5.0 by barry Nice!!
Clean look and easy to program. Very easy on install & operation.
October 4, 2016
Rated 5.0 out of 5.0 by LP0668 Great opener
This keypad works great with my Genie garage door opener. Very simple to install and program. Would purchase again.
September 27, 2016
Rated 5.0 out of 5.0 by papa Replacement Keyless Garage Entry
Original key pad finally expired...This replacement was easily programmed (I read the instructions!).
September 20, 2016
Rated 5.0 out of 5.0 by TX Works just fine
Bought one to add to a garage that didn't have a keyless entry. Took a couple of tries to setup the programming. Was originally standing too close to the actual opener. Moved back a few feet and the programming worked as instructed. To get the placement holes set correctly, first put in the top screw. Then hang the unit loosely and use the hole in the bottom of the unit to mark the second drill point. Remove the unit and drill the bottom hole. Then put the unit back on the wall and snug it down on top and bottom. Liked the unit so much, I bought a second one to replace my mother in-laws unit that broke.
August 2, 2016
Rated 5.0 out of 5.0 by Travis Easy swap
I had an older genie door opener that had broke. I'd usually have to enter the code 4+ times to get it to work. This new one however takes 1 time and works perfect every time. Easy install and easy instructions.
September 13, 2016
Rated 5.0 out of 5.0 by Jay Keyless keypad
I bought this keypad to have a second device to gain entry into my garage/house. I had no problems setting this up with my Genie garage opener system. Just remember this unit is for older systems and you have to look at your dip switches on either your garage door opener remotes or the main garaged door opener motor and read the directions to install the unit. I just took the remote apart and looked at the dip switches in there and then went by the direction and programmed the unit.
August 21, 2016