Rated 3.8 out of 5 by 4
Rated 3.0 out of 5.0 by Pacer53 This product performs as advertised but...
This project involved installing the valve after the initial project was complete. The valve guide caused me to make a larger hole in the tile than requred and almost was too big for the cover plate. In addition, the valve handle is held on with a set screw which I could never get it tight enough to hold and had to use a little silicone to make it stay. The cover plate is only held in place with silicone and if the valve is not set with the proper depth, if will not fit.
Since installation, the valve has performed well and there have been no leaks.
April 9, 2013
Rated 4.0 out of 5.0 by Trammel Would use again
The only thing I did wrong was estimate how far out to mount this. I had to unscrew the face about half way in order to get the flange to fit. The handle loosens up after some use but I chalk that up to not having it properly away from the wall.
I am able to run one or two heads at once out of the three shower heads I have installed. You can even feel when you get to the middle point between. Nice constunction.
April 13, 2012
Rated 4.0 out of 5.0 by Motorcycleman GREAT PRODUCT, BAD HANDLE/KNOB DESIGN
The three way diverter valve works great. I installed it about eighteen years ago. The problem is the handle/knob design to secure the handle/knob onto the valve. I had to buy a whole new unit just to get a replacement handle/knob. The lock screw is very difficult to tighten. It is designed as a hand tighten only. No screw driver.
March 20, 2012
Rated 4.0 out of 5.0 by JRuss Not bad
It looks great and works even better. The only issue I had was that the plastic cover which comes preinstalled is not an accurate guide for setting the depth of the value. Be sure that you allow plenty of room so that the trim ring will easily cover the value after instillation.
February 13, 2008