Questions and Answers for RIDGID 11 Amp 2 HP 1/2 in. Corded Fixed Base Router

A:  The picture I saw did not show a plunge base - this is not a plunge router

A:  Hi Marc, Sorry for the confusion this did come with a plunge base as a special offer but that offer is no longer valid. I will get the photos corrected to reflect the actual product. Thanks for letting us know. Greg

A:  Hi JMan, The depth of cut is 0 to 2". Hope this helps. Greg

A:  Three and five eighths inches (3.625"). Measured 2x with a Stanley tape measure, not a micrometer.

A:  Hi DCG, Sorry but we can only recommend using this tool only for it intended base. Thanks for asking. Greg

A:  You need to use the alignment cone and pin. The pin goes in the half inch collate and the cone rests in the baseplate, and slips over the pin.

A:  I'm not sure I understand your question exactly. Are you trying to mount this to a router table? If you're trying to mount it to some type of universal plate it should fit. As you can tell, there are many different hole patterns. Something that might help is to take the clear base plate from the router, mark the holes you use on it and then slowly rotate that over the router table base plate until you find the 3 correct ones. Personally, I wouldn't drill any holes.

A:  Hi Joanne, If you are referring to a router table, according to the manual that router should fit the router table using A1, A3, and A5.

A:  Hello Rob, Thanks for your question. The below response is correct. It does not come with an edge guide, but you can purchase one separately.

A:  No it does not. They do have an accessory option for it though.

A:  NO

A:  no it does not

A:  No, nor does HD carry one. But search online for Ridgid part #300869006. They're around $25US plus shipping.

A:  You would have to consulate the manufacturer of the router plate you are looking at to see which one fits this model. Or you can get the blank plate and drill the holes yourself.

A:  Thanks for your question. Please refer to the user manual which can also be found on the home depot website.

A:  don't need a router lift the t handle that comes with it does that from the bottom by simply unlocking the clamp on the side and inserting the handle from the bottom, adjusting then relocking the clamp.

A:  Hi ChrisS, The model number for the power head is R22002. Thanks for asking. Greg

A:  The R22002 is a package that contains the motor and the fixed base. The motor is R2901. I verified this by a Ridgid tech. The Kreg lift works great.

A:  15/16"

A:  Hi Mrk62554, That takes a 3/16" hex size. Thanks for asking. Greg

A:  Hi Swanny, The base does come off. Thanks for asking. Greg

A:  I bought the Kreg lift which worked perfectly. Not sure about the Rockler but the base does come off.

A:  Yes they make a universal base plate to match it up.

A:  Hi Bruce. You can Use the Ryobi universal router table A25RT03. Thanks for your interest. Greg