Mueller Global 1 in. PVC Irrigation Compression Slide Repair Coupling-160-505HC at The Home Depot

Mueller Global

Model # 160-505HC

Internet # 100175547

Store SKU # 795097

1 in. PVC Irrigation Compression Slide Repair Coupling

Mueller Global 1 in. PVC Irrigation Compression Slide Repair Coupling

This item has been discontinued.
The Home Depot no longer carries this specific product.

$4.13 / each


Model # 160-505HC

Internet # 100175547

Store SKU # 795097

This Mueller Global 1 in. PVC Irrigation Compression Slide Repair Coupling expands from 8-3/4 in. to 11-3/4 in. for use in repairs of irrigation PVC pipe.

  • Heavy PVC construction
  • Designed for solvent welding in new or existing PVC pipe lines
  • For use with cold-water lines and repairs of irrigation PVC pipe
  • Compression connection type
  • Maximum working pressure of 160 psi
  • Double O-ring seal to help provide additional leak protection
  • Expands from 8-3/4 in. to 11-1/4 in.
  • Restrain pipe after installation


Assembled Depth (in.)  8.75 in  Assembled Height (in.)  2.75 in 
Assembled Width (in.)  2.75 in  Compatible Pipe Material  PVC 
Connection  Slip-Joint x Spigot  Fitting 1 size  1" 
Fitting 2 size  1"  Fitting or Connector Type  Adapter or Coupling 
Manufacturer Warranty  1 YEAR  Material  PVC 
Maximum working pressure (psi)  160.0  Pipe or Fitting Product Type  Fittings & Connectors 
Product Height (in.)  2.75 in  Product Length (in.)  8.75 in 
Product Weight (lb.)  0.66 lb  Product Width (in.)  2.75 in 
Push to connect  No  Underground rated  No 


Rated 4 out of 5 by 7 reviewers.
Rated 3 out of 5 by Easy to install...but mine leaks Easy to install... had to cut out length of PVC as the coupler is long.... installed just fine.... PVC glue on each end.... turned on the water... hooray! Good thing I decided to not bury it immediately...... leaking through the telescoping part..... Will see if I can fix, All O-rings seated, etc. etc. Going to try either silicon glue inside the slider or PVC glue... hope I can get it tightened before it sets.... If not.. due to location, I will have to dig up a large hole, replace at least a few T's and several sections of PVC... as the location of this repair is very close to T' and the pump... and not enough PVC left before the T and pump to be able to cut it out.... Ugg..... September 15, 2014
Rated 4 out of 5 by Works as designed in my case Have used on 4 different occasions including one to be done this evening. In each case, they have worked as they are designed to do and has simplified the splicing task; especially in those cases where you have little room to work. May 2, 2012
Rated 5 out of 5 by Useful The product is reliable when used correctly. Make sure the slide and the body are seated and tightened correctly before installation. If you are not burying the pipe in the location of the fix then you must restrain by some other means. An unbelievable time/energy saver. May 14, 2014
Rated 5 out of 5 by Repair Coupling I have used this type and brand coupling to repair several different sprinkler systems. My current system has had three repairs on three different zones of which all were on the 1" main zone feeder lines. The repairs are easy to make and do not require you to dig large holes to gain flexability in the line you are trying to repair. My only caution is to check and tighten the female end of the fitting. Inside of the coupling is a rubber gasket/washer. If the fitting is not tight, it will leak. May 28, 2013
Rated 5 out of 5 by Headache saver! After trying to replace an irrigation valve and not getting much flexibility in the existing pipes I cracked the main line at the edge of my hole. Sent my wonderful licensed irrigator (that'd be my wife) to HD for new coupling while I dug bigger hole to get flexibility in the pipe. She brings this coupler back. Worked like a charm...could have saved me an hour had I purchased it from the get go. April 7, 2014
2 >>


Store Exclusive. This item is available for purchase in select stores only.