Rated 3.2 out of 5Â by 11
Rated 1.0 out of 5.0Â by shawn JUNK
I don't know what everyone likes about this wood, it's junk! First it has this "string" stuff inside (sort of like dental floss) and if you pull on it the whole piece rips out. Also, the edges will splinter when cut and apparently they used poor quality glue b/c it separates right away (made in Ecuoidor). And at $35 ea this IS NOT a good value!
September 16, 2014
Rated 1.0 out of 5.0Â by tedstriker777 the worst
This sande ply is total garbage. Layers of particle board hiding between layers of real wood. Another corporate American way to increase profits at our expense. I've seen some of it with Masonite mixed in as well. Let them have to eat trainloads of this junk to pay for their attempt to sell us plywood that isn't plywood.
I wouldn't recommend it's use for anything. I took a 4x8 sheet back, even after I had cut it and drilled through it, and demanded a complete refund, which I got. They know it's a scam.
November 8, 2014
Rated 1.0 out of 5.0Â by Miles Bad shipment or bad supplier?
I purchased 3 sheets for a custom cabinet that was to be finished with urethane. Apparently, I got 3 bad pieces (what are the odds?) because each sheet had voids in the veneer, and at the cut edges the veneer would peel up due to NO glue between veneer and underply. Just bad quality finishing plywood at a high price.
August 5, 2014
Rated 3.0 out of 5.0Â by RednexToyz Like the surface finish but.........
I use this to make drawers for my cabinets. I like the surface finish when completed but....... Take care when cutting and use a high tooth count blade. The face finish will splinter at the edges. The last couple sheets of this I purchased had a LOT of interior voids which can manifest themselves along an exposed edge of a drawer (for example).
March 11, 2013
Rated 5.0 out of 5.0Â by SaintPatrick Great for cabinets and fine woodworking
The 1/2 Hardwood Plywood is excellent for all your cabinet and finish project needs where you want the great look of tight grained wood.
Using different stains and methods of applying the stains s a snap and there is significantly enough top grain so if you make a mistake a little sanding and linseed oil can correct the problem. I dropped a small can of stain and it splattered on a board I was getting ready to stain and I was able to salvage the piece without too much trouble.
The plywood cuts well with very little splintering of the veneer on the back side but I do recommend a high tooth count blade with reliefs when doing two sided cabinet work. You can use a tape on the cut line or even pre-score he cut to reduce this but my best success with a general cutting blade has been make my cuts after staining and a the first coat of poly. Two coats of poly makes a deep grained gloss with very little ( if any) sanding.
This is an easy to use wood product which gives great results.
March 15, 2010