Rated 4.2 out of 5 by 29
Rated 5.0 out of 5.0 by Rodical2 Easy to cut and assemble
Venting a new bathroom fan. I had no problems cutting the pieces into correct length and attaching them together and to the fan housing and house structure.
July 19, 2016
Rated 5.0 out of 5.0 by Bill Duct Pipe purchase
verry good product, I will ware gloves if I need to purchase add'l since I'm on blood thinners... there are share edges which come into play when installing. VERY SATISFIED>
April 19, 2016
Rated 1.0 out of 5.0 by Phantom SNAP LOCK HORRIBLE
Snap lock difficult to snap pipe together, ended up throwing pipe away and using flex instead.
April 2, 2016
Rated 2.0 out of 5.0 by JackOfAllTrades manufacturing defect made it hard to use
I would have preferred a pre-assembled pipe, but this is what I could find. One end snapped together readily, but the rest would not. After a lot of failed attempts, I noticed that the tab on one end was about half as long as the tab on the other end, and that was why it refused to go together. I finally forced it into place by using a hose clamp to squeeze it together and then moving it an inch or so at a time. Once I forced it together, it stayed together ok.
March 1, 2016
Rated 1.0 out of 5.0 by JimmysDogs Absolute TRASH, avoid at all costs
This product turned an easy dryer vent install into a massive and time consuming headache. I had purchased two five-foot sections to be used in my dryer vent system. I used one piece to run outside of my home, the opening would not fit my dryer vent face. The inner dimension of the duct wasn't even remotely close to 4", I would say it was as small as 3.75" but didn't get an honest measurement. After much work I was able to make it fit, but I probably spent 25 minutes working, when it should've taken 25 seconds. After that, I attempted to connect the second piece of this to the first, it wouldn't fit, now keep in mind this is the exact same product that wouldn't fit into another piece in the exact same lot. Again after much work I was able to get it together. Fitting the elbow joints into this stuff was another project by itself.
I will NEVER buy this trash again, all of the other parts of my dryer exhaust system fit together with absolutely no problems. Adding just two pieces of this trash to my line, took my 15 minute project to a 3 hour project. Avoid this stuff like the plague.
March 9, 2016
Rated 4.0 out of 5.0 by LDMSR Used for dust collection system, lots of taping
Not for a dust collection system to many seams to tape.
February 10, 2016
Rated 5.0 out of 5.0 by SWOKLandlord Great for relocating dryer vent.
The 5 ft. sections are nice when you have to run a long distance and need a rigid vent. I used this on a recently acquired rental house that someone had relocated the dryer connection on, but did not run a new vent.
July 12, 2014
Rated 2.0 out of 5.0 by Techineer Tape the seam!
The snap seam popped open on me after it was installed. Caused all kinds of problems.... I recommend that you use some aluminum foil tape to cover the seam and hold it together when assembled. Unless it is carrying hot gas... then screw it together. Other than that, it was fine.
January 12, 2016