Rated 4.2 out of 5 by 6
Rated 5.0 out of 5.0 by SDguy No lasting smell!
I just used this on on my hinges in the house and I have to say that it works great. It dried very quickly and had no lasting odor.
December 15, 2011
Rated 5.0 out of 5.0 by Celia Great on stuck windows
This stuff does a GREAT job on stuck windows! The propellant evaporates immediately and leaves behind the lubricant. It's dry so it doesn't go away, attract dirt, or get sticky. We can open our 35 year old windows with one finger now. I know this because I proved it to my husband!!
August 31, 2013
Rated 5.0 out of 5.0 by Comtech Great for low-compression fixes
This is essentially the lubricant PTFE in spray form. It is not a 'compression' lubricant for such purposes as the metal gears of heavy machinery. It is best suited to sliding parts, such as drawers, windows, locks and other such light mechanical systems. For those purposes it is extremely effective.
It has to be well shaken to mix the powdered PTFE with the wetting agent, and to comes out very wet, easily penetrating hard to reach places where it dries to a slick, thin white coating that is easy to clean up where there is excess. After penetration you have to let it dry and not use the device while it forms this slippery coating. This is the same process for applying other dry lubricants.
I've used this for a number of things, but I'm most impressed with how well it lubs small fans, such as the fans in computers which I often have to lubricate to stop them from making noise. Obviously it is only a temporary fix for any lubricant because all lubricants eventually work their way out from the points of contact, but rather than replace a fan that is fine for a few years if lubricated properly, I'd rather spend my money on this stuff.
May 13, 2015
Rated 5.0 out of 5.0 by none Great Stuff
I have used this on my garage door, my table saw top, rip fence, and cross cut miter gage slots, door hinges, tools, and about anything else one could name. It dries super fast and works very well in all my applications. No complaints about this product, it works great.
November 1, 2011
Rated 1.0 out of 5.0 by Metamerman Worst lube ever!
This stuff is horrible: I used it on two things, a bike chain and the wheels on a dryer drum and it failed miserably for both. It is easy to use and dries fast, but the resulting film does not stick to the parts! Instead it just rubs off leaving a talcum-powder-like substance all over the surrounding area. In the case of the dryer drum, the powder actually gummed up the bearings to the point they wouldn't turn and so the dryer wouldn't start. So I had to take the whole thing apart again, clean this stuff off, and go back to my usual lube (Triflow, which HD unfortunately doesn't carry) which works *so* much better.
In fact it's so bad I think I'm done with dry lubes (other than using candles for drawer guides) and will only ever use wet lubes from now on. Avoid Blaster Dry Lube like the plague!
September 19, 2014
Rated 4.0 out of 5.0 by Jacob Unstuck my Ignition Key
I can only give testament to the results for a single purpose. I bought this product to un-stick my car key which was stuck in the ignition of my Toyota Avalon. The key would turn but not pull out. After a couple of squirts and a little jiggling, the key came out. I'm thrilled that I only spend $5 instead of hundreds of dollars on car repair.
December 14, 2014