Rated 3.8 out of 5 by 18
Rated 1.0 out of 5.0 by Murrayguy Get a diamond bit
Got about one third the way through the first hole in the shower tile to hang the shower rod. The bit just polished the bottom of the hole - no more cutting. Useless.
I bought a diamond bit to finish the job.
August 2, 2016
Rated 5.0 out of 5.0 by happycustomer sweet bit!!
Needed four holes in a tiled shower for a curved curtain rod calling for a 1/4" bit. Picked this bad boy up, marked my holes, and had all four holes drilled out in less than a minute. It was AWESOME. Made the job quick and easy. It does walk a tiny tiny bit so just take the start a little slow. It does make a mess so put some plastic down for a quick clean up. I used a trashbag and that worked for me. Seriously... This bit is the real deal. Super clean holes too.
December 11, 2015
Rated 3.0 out of 5.0 by PICARDCO Adequate
I had 12 holes to drill to install 2 ADA grab bars in a shower that we remodeled for a disabled veteran. I went through 3 bits before I was done. They did drill a very nice hole and the tile did not crack.
June 21, 2016
Rated 1.0 out of 5.0 by Jb Clean holes, but it doesn't last
Maybe it was my tile, but I expected this to at least work for a couple of uses. I was able to make 2 holes and then I had to buy another one which only made one hole. So had to get a third one. It was a bit fustrsting as I asked an associate if they offered something different and they said this was the only product they sell to do this kind of task
May 31, 2016
Rated 5.0 out of 5.0 by Joe Almost as good as "Chicken 'N Dumplins"
Long story short. Needed grab bar for tile shower. Ordered 32" Moen bar from HD. (Great Buy). Used a combination of magnetic and Zircon stud finder plus a plumb bob for exact location of stud sides. Had painters tape on tile wall for hole markings. Used this bit (At very slow speed With Water sprayed on it to cool it). For less than 9 bucks, this bit drilled 6 holes flawlessly with NO WALKING! Yup, this bit is the way to go. I would Highly Recommend it. (I got my Chicken 'N Dumplins" when finished). And I guarantee this grab bar is there to stay!! If you use this bit, you will never regret it. Just go slow and cool it with water spray.
February 13, 2016
Rated 5.0 out of 5.0 by Myers97470 Slow & Steady
I ran this bit a lot faster than recommended, with lots of water, on a brand new tile that was harder than masonry or brick. It took a while, but made it through four holes for a towel bar. I used a masonry drill to make a pilot hole before putting this gem to work!
May 31, 2016
Rated 3.0 out of 5.0 by macolla Glass and tile bit
I can only drill one tile hole with this drill bit
March 23, 2016
Rated 5.0 out of 5.0 by Mylo Worked great
This bit worked perfectly on my project. I am thoroughly satisfied with the results.
February 10, 2016