Rated 2.3 out of 5 by 34
Rated 1.0 out of 5.0 by David Pitch the instructions
It quickly became obvious that the person who wrote the instruction's first language is not English. Look at the diagram to see how it goes together, and then put the instructions aside. The slide extension nipple does not have a hole. It has a dimple. You need to carefully drill it out, starting with a small pilot hole, and then drill it completely out, so you can see the slot in adapter A. The hole needs to be drilled big enough for the screw E to go through it without effort. Be careful when drilling not to punch through, and mess up the threads on the opposite side of the inner threads. Push the extension tube up against the tub wall, slide adapter A on, and tighten it up, where you can still see the slot through your drilled hole. Then put slider retainer ring D on. Run the screw down, almost all the way, until you hit the copper pipe. It has to be tight, or water pressure is going to blow it off. Works fine this way. A lot of hassle to figure that out.
June 23, 2016
Rated 5.0 out of 5.0 by Stan Good Purchase
Slid right to place with a vaseoline. Easy to install.
June 21, 2016
Rated 1.0 out of 5.0 by Wes0311 Glad to see I wasn't the only one
After struggling with getting the plastic adapters to line up, the non-holding mounting screw, and finally the water blasting out the back when testing the diverter it was redeeming to see just about everyone hates this piece of junk. Taking it back. Ignore these reviews at your peril.
June 26, 2016
Rated 5.0 out of 5.0 by eddie Rub spout replacement
Perfect replacement and it works and looks great .
May 10, 2016
Rated 2.0 out of 5.0 by scifier Waste of Money
I finally finished my bathroom remodel and there’s only one thing wrong with it… This dirty looking Tub Spout does not matchup with my other brush nickel fixtures. It looks terrible compared to what a lighter brush nickel should look like. It also leaks like a faucet after pulling up on the diverter. I wish I would have saved the receipt because I’m definitely going to swap this out for something better.
August 13, 2015
Rated 1.0 out of 5.0 by Steven Terrible
Had the same issues as everyone else. Followed the directions very closely and it leaked excessively. Very poor quality.
April 8, 2016
Rated 4.0 out of 5.0 by Grandpa24 Replacement bath tub spout
The replacement tub spout contained all of the necessary parts, even the vinyl tape, needed to install it. It took only 10 minutes to install the new spout. It took 20 minutes to loosen the old one!!!
March 22, 2016
Rated 1.0 out of 5.0 by Nathan Avoid this if you can
If you are buying a new spout, then avoid it. If you are stuck with an existing one like I was, these three things helped me fix it:
A) forget about aligning holes. It took me forever and I still couldn't get them aligned.
B) replaced the screw from the kit with a socket cap screw (button HD). This helped me used L-key to tighten the sleeve. Philips screwdriver is no good when you are that close to the wall. But take a rough measurement of how deep your screw can go without impacting your copper pipe and tighten accordingly.
C) Teflon tape is a must before you screw on the spout. Else it's guaranteed to leak.
January 19, 2016