Rated 3.5 out of 5Â by 11
Rated 3 out of 5Â by RGV4 Not a full 3"
I needed to replace the flush valve assembly on my American Standard Cadet 3 toilet because I could not find a replacement gasket. The inside diameter of the Cadet 3 flush valve throat was/is 3.25 inches.
The inside diameter of the Fluidmaster Universal flush valve throat is only 2.8"
So far it seems to flush OK with the flapper set on 9 which is next to the longest flush setting but I am worried that it might have difficulty with larger bowl fills.
September 1, 2011
Rated 1 out of 5Â by thewordofb cheap quality
The rubber gaskets aren't great quality with rough spots in the rubber. This just never quite had a good water-tight seal between the tank and the valve.
November 2, 2013
Rated 3 out of 5Â by kbentl0424 Product has flaws
Flipper after flush does not always align properly. Have taken things a part and installed several times. Flipper is included as a piece of the part. Most times it will seal upon refill. However, sometimes it will not seal completely and the toilet will run until the flipper is manually adjusted. Might have gotten a defected part so I will leave judgement since this might just be an outlayer. Still very frustrating!
January 14, 2014
Rated 5 out of 5Â by PatF Very good replacement valve.
Easy to install. Arrived by UPS as specified. Very pleased with HomeDepot.com. Just wish the local store would handle this product.
June 26, 2012
Rated 5 out of 5Â by lt60 Replace Glacier Bay internals so parts can be found.
Installed a Glacier Bay toilet and hated the flapper. Can't get parts for it so I replaced the entire flush valve with a Flowmaster. Now parts can be gotten anywhere, plus it is adjustable rather than fixed..
March 12, 2013