Rated 4.0 out of 5 by 20
Rated 2.0 out of 5.0 by Graceland316 Saddle valve leaked
I am pretty good with most things but this saddle valve would not stop leaking. I had scuffed up the area prior to using the valve just to make sure there where no issues. I followed the instructions to the letter - pretty straightforward. It leaked. The piercing went okay into the copper like but the rubber gasket would not seal.
What to do? Googled it. They recommend a t-fitting and a compressed coupling. Works great now!
September 20, 2016
Rated 4.0 out of 5.0 by tinmanintherain Gets the job done!
Fits well, I feel more comfortable using this copper line versus a plastic line. Included everything I needed to install.
August 2, 2016
Rated 5.0 out of 5.0 by icemaker UNIVERSAL 15 FT. COPPER ICE MAKER INSTALLATION KIT
I was going to make my own out of plastic tube. It was the same price and the Home Depot guy told me use the copper it won't fail.
June 7, 2016
Rated 5.0 out of 5.0 by Jennifer Easy to install
This product worked great and it was easy to install.
June 7, 2016
Rated 5.0 out of 5.0 by LifeIsGood Works great
Just got a fridge with a water dispenser and ice maker so I go this. I'm handy and have done minor plumbing work, but the instruction on which small pieces go where is lacking. I ended up with 1 white plastic spacer/washer that I didn't use as I couldn't fit it anywhere. Still, without it, I have NO LEAK. I tapped under the sink, drilled holes at the lowest point of 2 sections of cabinet and drawers walls for the copper line to go through.
March 30, 2016
Rated 5.0 out of 5.0 by JSG55 Perfect and nice quality
Did the job great and no leaks and seems a lot better than plastic kits.
March 1, 2016
Rated 5.0 out of 5.0 by Diogino Worked great
Quick and easy. Use this rather than plastic......
March 15, 2016
Rated 3.0 out of 5.0 by Daehenob Worked
It was a copper tube and saddle valve (which I didn't use). I was installing an ice maker and didn't want to run plastic to the floor feed for the water. I also didn't want to use a saddle valve so instead I used a shark bite 3/4 in x 3/8 in x 3/4 in ball valve instead. I don't see the thrill with saddle valves especially since the pressure is completely relying on a piece of rubber which could easily be susceptible to dry rot or other corrosion. A Sharke Bite is a sealed unit that in my case sweated in and is working perfectly. From the floor to the fridge I used the plastic line which worked flawlessly but is also now easily replaced in case of failure.
September 22, 2015