Rated 4.0 out of 5 by 41
Rated 5.0 out of 5.0 by RescueSwimmer Angle offset adapter
A wonderful addition to a cordless drill, and toolbox for getting to that angle you kist cant reach with the deill itself.
October 8, 2016
Rated 1.0 out of 5.0 by runforfun7 Sadly Surprised by Lack of Quality
It completely fell apart the first time I used it. It seems a small plastic ring was all that held pressure on the two gears. The project I was using it on was so I could put a great deal of force upward to keep the two gears in place. Something should be done to keep those two gears in place better. I took it back and got a refund the next day. As always, Home Depot was perfectly good on the return process. Found another tool there that did the job. The gears on this looked very sturdy, but the pieces that hold them together is another story.
August 16, 2016
Rated 5.0 out of 5.0 by artie Practical
Great for tight places, I even use it with a 1/4" nut driver. Last one I had lasted over 10 years in commercial use.
September 1, 2016
Rated 3.0 out of 5.0 by Rob Light duty
I bought this for a specific job. I had to reach back and drill a hole in a wooden cabinet. Worked fine however it was built with very loose tolerances and is quite "wobbly". Would be fine for the occasional hole in plastic or wood. Not professional grade by any means, but also not a professional grate price. If you are a DIY person, will work fine. I would not recommend it to contractors.
August 4, 2016
Rated 5.0 out of 5.0 by JoeShmo Extremely handy
Great product, for use removing or installing screws in small area.
August 23, 2016
Rated 5.0 out of 5.0 by Tiny Perfect tool
This is a great tool for tight spots works great for a audio installer small spots A+++++
July 26, 2016
Rated 4.0 out of 5.0 by Flogger Milwaukee hex bit offset driver
Very useful for installing hardware in cabinets and other awkward situations.
May 24, 2016
Rated 4.0 out of 5.0 by Willie Best little tool ever
Excellent for tight to reach furniture assembly projects, shaved about two hours from a project I did today. Last week I assembled almost the same piece, I immediately notice the difference in the time it took when I used this tool.
May 16, 2015