Rated 3.7 out of 5 by 18
Rated 1.0 out of 5.0 by Alex DO NOT BUY!!
Again it is a cheap Chinese made product that will rust within minutes of moisture contact. I couldn't believe that after the first day of use the entire knife started rusting very badly. So much for a fake looking stainless steel product. I will never buy this product again and please stop selling cheap Chinese made tools.
April 10, 2016
Rated 1.0 out of 5.0 by pjclark4 Rust after second use
I used this twice. I've been dealing with dry wall and dry wall tools for 25 years. I rinsed it with water immediately after both uses, dried with a rag, and then air dried without the blade touching anything. Went to use it a third time, 24 hours after the last coat, and it had rust spots that were rough to the touch. You can't expect a smooth finish with that, so this tool I purchased five days ago is now worthless.
I will take it back to HD to try and get a refund, but I'd love to hear the manufacture chime in here with an explanation.
March 14, 2016
Rated 1.0 out of 5.0 by edb90 rusted after first use
used this spackle knife, cleaned when I was done went to use the next day and it had rust spots on it
March 20, 2016
Rated 5.0 out of 5.0 by Grampy Worked great in kitchen over haul
DId the job. Used 5 gallons of drywall spakle with it
April 28, 2015
Rated 4.0 out of 5.0 by drywallguy 6 IN. HAMMER-END JOINT KNIFE
ok so it was used as a drywall knife applying drywall mud. doesn't set any screws and no one uses nails any more. Mostly use the end to tap in flys.
February 24, 2015
Rated 4.0 out of 5.0 by Jake1969 Right tool for the job
This knife was perfect for the few minor patches I had in Sheetrock. I was able to make my repairs and had minimal sanding to do.
February 17, 2015
Rated 3.0 out of 5.0 by Mudman Does the job
This is a taping knife, which I think is more flexible than a “putty” knife. This is what I wanted, but would have preferred a 5” (that nobody apparently makes anymore, for some strange reason). The rivets in the handle did loosen somewhat, but I don’t think they will come out and it does not really affect the function. Should not have happened though and is why I only gave it an "average" rating.
October 7, 2014
Rated 4.0 out of 5.0 by THECCLLCcom Bend the corners
A small trowel like this is good to have in your arsenal for touch ups where larger trowels left behind trail lines. Just has a hammer to tap /hit each side of one of these trowels, or bend the corners, just very small bend and maybe an 8th to 3/8ths wide area - it will make a perfect finish with no trails! On a lot of other trowels, you dont want to do this because they have a side that is bowed in and a side bowed out (ever so very very slightly). Use which ever side you need depending on the joint or what have you that you are trying to finish!
March 30, 2010