Rated 4.1 out of 5 by 14
Rated 5.0 out of 5.0 by happycustomer sweet bit!!
Needed four holes in a tiled shower for a curved curtain rod calling for a 1/4" bit. Picked this bad boy up, marked my holes, and had all four holes drilled out in less than a minute. It was AWESOME. Made the job quick and easy. It does walk a tiny tiny bit so just take the start a little slow. It does make a mess so put some plastic down for a quick clean up. I used a trashbag and that worked for me. Seriously... This bit is the real deal. Super clean holes too.
December 11, 2015
Rated 5.0 out of 5.0 by Joe Almost as good as "Chicken 'N Dumplins"
Long story short. Needed grab bar for tile shower. Ordered 32" Moen bar from HD. (Great Buy). Used a combination of magnetic and Zircon stud finder plus a plumb bob for exact location of stud sides. Had painters tape on tile wall for hole markings. Used this bit (At very slow speed With Water sprayed on it to cool it). For less than 9 bucks, this bit drilled 6 holes flawlessly with NO WALKING! Yup, this bit is the way to go. I would Highly Recommend it. (I got my Chicken 'N Dumplins" when finished). And I guarantee this grab bar is there to stay!! If you use this bit, you will never regret it. Just go slow and cool it with water spray.
February 13, 2016
Rated 3.0 out of 5.0 by macolla Glass and tile bit
I can only drill one tile hole with this drill bit
March 23, 2016
Rated 5.0 out of 5.0 by Mylo Worked great
This bit worked perfectly on my project. I am thoroughly satisfied with the results.
February 10, 2016
Rated 2.0 out of 5.0 by dave Not very strong
It needs to be dipped in water every 5 seconds. Not a strong bit
December 29, 2015
Rated 5.0 out of 5.0 by BusyB These bits work really well for drilling in tile
When drtlling tile these bits can do about ten holes before they dull
December 8, 2015
Rated 5.0 out of 5.0 by Darcy Excellent bit!
Bit is durable and more importantly, long lasting.
July 14, 2015
Rated 1.0 out of 5.0 by Uncle Waste of money
Needing to install two sets of bi-fold doors, I picked up a couple of these drill bits to drill holes into the ceramic tiled floor for the bottom bracket that the doors sit on. These bits cut terribly slow and the first one broke after cutting one hole. I went out and picked up a Vermont American glass/tile drill bit and couldn't be more satisfied. It cut fast and precise, and did multiple holes. Just look at the design and it will tell you the difference. The Vermont American bit has more blade edge. That equals better and faster cuts.
March 5, 2015