Rated 3.0 out of 5 by 2
Rated 5.0 out of 5.0 by Breathless Hand and Forgiving
Had it installed in my car to control a CPI 1000 inverter used to power portable oxygen generating equipment. Installed to isolate inverter from battery when engine is not operating so it shuts down when ignition is turned off and will not turn on until pressed after engine start. Just what I needed. Only distraction is the large footprint of the mounting plate. Made it a bit difficult to locate.
April 22, 2016
Rated 1.0 out of 5.0 by PURDY POOR EXAMPLE
THE REMOTE SWITCH ARRIVED AND TO OUR SURPRISE IT WAS ONLY A FACE PLATE WITH A SMALL CIRCUT BOARD ATTACHED TO THE REAR WITH A CORD GOING OUT FROM THAT. THERE WAS NO WAY TO MOUNT THE UNIT TO A FLAT SURFACE AS THERE WAS NO ENCLOSURE AROUND THE REAR OF THE UNIT. THE CORD SEEMED VERY WEAK AS IT COULD EASILY BE PULLED FROM THE UNIT. I WOULD NOT SUGGEST ANYONE PURCHASE THIS UNIT TILL AN ENCLOSER IS ADDED.
July 24, 2014