Rated 4.3 out of 5 by 113
Rated 5.0 out of 5.0 by CoriElyse Perfect for Backsplash Install
This was the best purchase I could have ever made. One gallon completed our entire 42 sq foot kitchen backsplash with some left over. The best part of this tile adhesive is that you dont have to pre-mix new stuff every 20 minutes. If you take a break, just put the lid back on. You're also guaranteed consistency when its pre-mixed. We used 12x12" mosaic tile sheets along with 12"x3" glass tile accent. There was absolutely no movement of the tile once placed and pressed on. We used a 3/16" trowel and was dry in 12 hours. We let it sit a full 24 hours before grouting, but was definitely hard as a rock well before then. As a tiling beginner, I couldn't recommend this stuff enough :)
November 28, 2014
Rated 5.0 out of 5.0 by DLTorrens FANTASTIC PRODUCT - highly recommend!
Tried to save money by using the same mortar that I used to lay the kitchen floor tiles. BIG MISTAKE! I could not get the consistancy correct and just ended up wasting time and the kitchen back splash tiles kept sliding down the wall before the mortar would dry. With this product, they quickly adhered to the wall and I was instantly able to create the kitchen back splash. The tiles were straight and perfectly aligned and they look fantastic! Project was a success with this product!
June 3, 2014
Rated 5.0 out of 5.0 by CaptainHer0 3 years, so far so good....
Redid bathroom 3 years ago using this product. Floor to ceiling tiles. So far no loose tiles or any issues to report.
April 9, 2014
Rated 4.0 out of 5.0 by Handyman Worked as advertised
We were working in the house and didn't want the mess of mixing it ourselves. We started out using way too much but realized we needed less part way through ou first project. We did a tile bath surround and a kitchen counter top. It is went down well and didn't dry too fast. It is holding up beautifully.
March 17, 2015
Rated 4.0 out of 5.0 by Fridge79 Excellent product
This adhesive worked well with our application of tiles as a chair rail in a bathroom. The only issue is it was too "creamy" to support the heavier top and bottom pieces, so had to use a lot of painters tape to hold in position while the adhesive set.
September 30, 2014
Rated 5.0 out of 5.0 by Duck Worked as expected sticking tile to the walls
We were tiling a bathroom and needed to hold tiles to vertical surfaces around the tub. The info we read said to use this type of mastic, so we purchased a gallon of it. We used nearly the entire gallon, but it did the job. I liked that the tiles did not sag at all while waiting for the adhesive to cure - I hardly needed the spacers at all!
April 29, 2014
Rated 5.0 out of 5.0 by junior acrylpro ceramic tile adhesive the best all around adhesive
For installation of ceramic tile for a back splash of our new kitchen cabinets I chose acrylpro for my project. Being a water based adhesive it provided ease of clean up quickly. We had adequate open time without being rushed to install; the tile including all cutting. I was quite pleased with the finished project.
December 21, 2012
Rated 5.0 out of 5.0 by Kim1550 New Backsplash in the Kitchen
This was my very first "solo" tile job. The mastic was a breeze to apply. Please also note the Behr paint that I used on the walls. Love Home Depot! But more, the people you have working there rock! They're always right there to help me. Not bad for an old lady eh?
February 5, 2014