Rated 4.7 out of 5 by 54
Rated 5.0 out of 5.0 by Nosedive Saw blade
Works great for job i purchased for. Cuts wrete clean and neat
July 26, 2016
Rated 5.0 out of 5.0 by XPLSV The Diablo D1296L is The Blade for Laminate Flooring
First off, I noticed when researching for a laminate flooring blade here on the Home Depot website that many of the Diable blade models are mixed together. This review is for the Diable D1296L 12 inch 96 teeth Laminate/Non-Ferrous circular saw blade. I put this on my DeWalt 12 inch sliding miter saw and the performance has been fantastic. I have completed a family room, two hallways, a closet, and a bedroom at this point with a laminate flooring which has an AC 4 rating. The blade cuts without splinter and is still storeroom sharp after more than 100 cuts. The aluminum oxide top layer on the laminate flooring really needs a blade like this...I used a wood blade on a hand tool for a specialty cut at one point and literally smoked that blade with two small cuts. This blade is a must-have for your laminate flooring project. I do make the cuts with the surface side up and with a full slide on the compound miter saw.
November 18, 2015
Rated 5.0 out of 5.0 by PAt Fantastic Blade
My work uses these blades and I bought one for myself
March 25, 2016
Rated 5.0 out of 5.0 by Woody007 Diablo saw blade
This is an excellent saw blade that leaves a perfect clean cut every time.
March 2, 2016
Rated 5.0 out of 5.0 by Canoemaker Great blade
This blade does very smooth cuts. Very happy with the performance.
February 10, 2016
Rated 5.0 out of 5.0 by Boatbud59 The best aluminum blade out there
The best aluminum blade out there. We do full time aluminum construction
April 1, 2014
Rated 5.0 out of 5.0 by JIM Great Blade
Apparently, you do get what you pay for. A big improvement over the ho-hum blades I have been using till now. The quality of the cut in soft and hard wood is very clean and smooth.
November 11, 2015
Rated 5.0 out of 5.0 by Wildmanbill Excellent blade for aluminum.
I bought this blade to cut aluminum railing for a deck and stairs. It made very smooth cuts, so no sanding was necessary. It cut accurately with no chatter, it was as if I was cutting wood. It was expensive but worth every penny as I didn't ruin any of this $1,200 railing.
July 21, 2015