Rated 4.8 out of 5 by 86
Rated 5.0 out of 5.0 by Saddlebum Does everything it claims!
I bought this saw blade to cut a ten foot conference room table that has a laminate top and bottom and is 1+1/4" of epoxy and compressed sawdust in the center. A very difficult material to cut. The Diablo blade went through it with no problem at all. I stopped every two feet to check the temperature of the blade and it was just slightly warm. The final cut left both laminates clean and neat. The Diablo exceeded my expectations (and that doesn't happen very often).
February 10, 2016
Rated 5.0 out of 5.0 by goodreason Nice Quality Blade
Been using different kinds of Diablo blades for well over a year. When the opportunity came up to try the non-ferrous/ blade there wasn't a question or not to try it. Tested it on different plastic pipes ranging from 1/2” to 2” with the same results and it performed as expected a very clean cut. The well designed and crafted blade has numerous laser cuts for heat expansion, thin kerf design, stabilizer vents, and heat expansion slots to make this one of the very best blades on the market. While, at the same time extending the life of the blade, which could be a mute point because it's guaranteed for life, with of course exceptions.
July 28, 2014
Rated 5.0 out of 5.0 by Dale Smooth cut
I recently replaced the thin plastic on the side light windows on my front door with 1/8 clear acrylic. The cuts were smooth and easy, making this job so quick and satisfying .
August 1, 2014
Rated 5.0 out of 5.0 by Papaw Unbelieavable Blade / Awesome!
We needed a blade to cut thru 18 guage metal and this blade handled it perfectly. And with the need to also cut plastic roofing, all we had to do was to turn the blade around to cut the plastic. Best purchase.
January 5, 2016
Rated 5.0 out of 5.0 by Islandpm Great blade
I bought this blade for my dewalt sliding miter saw to cut hurricane panels and it did not disappoint, after over 500 cuts through panels, studded angle and H header it still cut like brand new. The cuts were very smooth and I did not have to file at all, looked as good as if the panels were sheared. I would absolutely recommend this blade for aluminum cutting.
October 16, 2016
Rated 4.0 out of 5.0 by Linner317 Excellent
Works great! We had no complaints and we'll use the same brand in the future if needed.
October 15, 2016
Rated 5.0 out of 5.0 by Dan cuts like a hot knife through butter
Used for my crown molding install. Cuts are clean. Will use same blade for my hardwood, will add more detail to see how long it lasts.
October 5, 2016
Rated 5.0 out of 5.0 by Chris Great for fryreglet
I use this blade to cut fryreglet (aluminium) and leave a clean cut, it cut it like butter , no messy job
April 30, 2016