Rated 4.7 out of 5 by 7
Rated 5.0 out of 5.0 by valarian13 Quality product
The center trim installs easily. It takes several days to straighten after being rolled in the box. Looks great and gives a finished look to the center seam.
October 18, 2016
Rated 4.0 out of 5.0 by TDK Good way to join a floor
The only issue I had was this item is located in an area where there is a fair amount of "sand traffic." As The center trim was not fastened down and sand tends to get trapped underneath. I did not want to fasten it down right away. Still undecided if i will since it then becomes a more permanent installation.
May 10, 2016
Rated 5.0 out of 5.0 by Nadia Easy to install
This center joiner was easy to install on the G Flooring purchased separately. Only tools needed are a straight edge and a razor knife.
January 10, 2014
Rated 5.0 out of 5.0 by IDAdam Fill the gaps
Our room had a seam and occasionally dust or liquid would get under and was a pain to clean. When we added this seam strip all was solved. Our heavy wheeled tools roll over the seam easily. So far no wheels get stuck since it's ramped slightly.
May 6, 2014
Rated 5.0 out of 5.0 by OneL Works fine, a bit expensive
Quite simple to install and will, hopefully, keep water from going beneath the mats. At 20% of the cost of a 10 foot wide mat, this is expensive, but I don't want to glue the mat to the floor, so this is the best alternative.
July 1, 2014
Rated 4.0 out of 5.0 by Bill Needed Center Mating Trim For 2 Sections
I used this trim piece to connect two 10' x 24' flooring sections. Pretty easy to install. Fit one section's side and position the second section over the center trim piece as if it were installed. Then simply lift the section edge and using your "gloved" index finger let the section slide into the slot of the trim piece following all along till completed.
January 28, 2014
Rated 5.0 out of 5.0 by Carlton The product is real quality. It holds up to tires without comprising its appearance
A must add on to flooring products. Gives that finish touch to the flooring
October 2, 2013