Rated 4.3 out of 5 by 3
Rated 5.0 out of 5.0 by Pdrumdingle Track Lighting Connector
This connector was very easy to install. It is made so you cannot install it incorrectly.
January 27, 2016
Rated 5.0 out of 5.0 by BigBruce Easy 90 Degree to Install
What can I say, the 90 degree elbow easily plugs in and works fine as you are assembling the tracks.
September 24, 2013
Rated 3.0 out of 5.0 by MediaRoomInstallation Having Installation Issues? Read This!
I purchased four of the 4-foot Hampton Bay track lighting kits (4-foot track with three lights), along with three 8-foot pieces of linear track and one 4-foot piece of linear track. To connect all of this, I purchased 5 straight connectors and 2 90-degree connectors. This allowed me to create a large U-shaped track in a media room.
At the end of the day, the system looks good, and eventually, I was able to get it working properly. I will also say that you get pretty good bang-for-the-buck out of this system, even considering the manufacturing flaws I'm detailing in this review. However, the build quality of the internal track components is very poor, which can make installation a real problem if you're connecting multiple pieces of track to build your system.
My brother and I are extremely "handy" - we were able to properly install and anchor all of the track in one short evening. However, we were disappointed to find that when we hit the switch to power the system for the first time, only the first leg of our U-shape lit up. No power was flowing to the bottom of the U or its second leg. Subsequent fiddling revealed that each piece of the track worked individually, and the whole second leg worked by itself, but the bottom leg of the U was a no-go, and the system wasn't working together all at the same time.
We double-checked all connections, etc... and spent almost as much time fiddling with everything as we had spent installing it to try to determine the source of the problem. It turned out that the copper conductors inside each track (2 on one side and 1 on the other) are not long enough to go all the way to each end of the track, and most of them are not centered up inside the track pieces. Additionally, the plastic sleeves in which they are housed inside each side of the track can loosen and shift once you push a connecting piece into one end or the other. This sometimes results in some of the copper conductors failing to contact with the connectors you're trying to use to build your system.
I went back to the store and bought replacement track, only to find the same design flaw. Also, if you read some of the other reviews (which I didn't before my purchase), you'll notice the same flaw being mentioned. This really should be addressed by the manufacturer - it wouldn't be hard to fix.
In any case we (finally) found a solution. We reluctantly took each problematic piece of track down and carefully centered each copper piece inside its plastic sleeve. We did this by GENTLY tapping the copper pieces into place with a small screwdriver and hammer. Then we centered each plastic sleeve inside the track and locked these in place by installing a light at each end of the track. The pressure exerted by twisting the lights into position holds the plastic sleeves in place, assuring that the copper is still centered up inside. Next, we gently installed everything again. We did still find that there is an issue getting some of the pieces to properly connect with the 90 degree connectors in particular. Solution: jiggle them. a lot. LOL...but seriously, we were able to jiggle things a bit to get them to work. We also gently tapped the connectors fully in place with a small hammer to ensure the tightest connection possible. Eventually, it worked.
Hope this helps!
June 17, 2014