Rated 4.2 out of 5 by 115
Rated 5.0 out of 5.0 by DR Replacement
Installation was a breeze. Be sure to wipe interior of valve housing after pulling old one out, just in case of any build up residual. Tie a string to the clip that holds the valve in housing before you remove it so it doesn't drop behind the wall. I did use a puller that was made for this valve removal that I had purchased. Glad I did.
September 20, 2016
Rated 5.0 out of 5.0 by Gator787 Just minutes to install!
I terrified of fixing this leaky faucet, but after a short YouTube video and a trip to HD: done in 5 MIN!
September 2, 2016
Rated 3.0 out of 5.0 by greenthumb Not the greatest, but easy to repair and Moen stands behind.
Had the bath faucet for two years. Knob broke, then a week later cartridge stuck in the on position. had to turn off water to house. Bought a new cartridge to get fixed that day, but Moen will send new parts under lifetime warranty. I have had good experiences with Moen standing behind their warranty. This faucet is easy to repair.
September 5, 2016
Rated 5.0 out of 5.0 by Adi369 DIY plumbing
Easy to install. It took 10 minutes to replace the cartridge. Good product.
September 6, 2016
Rated 1.0 out of 5.0 by Thomas Avoid at all cost
This of"work" costs $40 it broke within 3 years of avg use. Get another brand, warned and avoid
August 29, 2016
Rated 4.0 out of 5.0 by RCM Not too bad...
Shower was dripping...so time to replace the cartridge. It was last replaced 6 years ago. They seem to last about that long.
Some tips: 1) take pics as you disassemble - they will come in handy later; 2) shove a towel under the assembly to prevent the clip from falling; 3) Slide a paper clip through the clip to be able to securely remove it and not have it drop.
Once installed, the water control is smooth once again and the dripping has stopped.
August 9, 2016
Rated 5.0 out of 5.0 by pacificbg The best solition
I install the product very easy.It is working excellent
August 24, 2016
Rated 3.0 out of 5.0 by Me Too expensive. But stopped the leak.
My shower cartridge began to leak after only 3 years. At $39 this is an expensive repair. I'm disappointed in Moen's quality/price. That being said the replacement was fairly easy after watching a couple of youtube videos. The little white plastic removal tool was essential to getting the old cartridge out. It took about 15 minutes of slowly rotating the cartridge back and forth with a set of channel locks on the plastic tool. Finally the cartridge slid out about half an inch on the beveled edge of the valve. It took another 10 minutes of pulling and then rotating with the tool to finally coax the old cartridge out. Remember to pay attention to the H/C label orientation of the old cartridge before removing and lube up the new cartridge rubber seals liberally with the included lubricant before installing.
August 6, 2016