Rated 4.0 out of 5 by 16
Rated 5.0 out of 5.0 by Drew Mountain Electrical Contractor Standard
I have two of these Hole Hawgs that drill holes all day long. They never fail and never give up. Five years into the Electrical Construction industry and still going strong. I don't see using any other product to get this particular job done.
September 26, 2016
Rated 5.0 out of 5.0 by Tom great tool
Used this drill to bore 2 1/8 holes in 47 timbers 6x8x8 pressure treated (thru the 6" part) never bogged down had plenty torque using self feeding bit.
June 28, 2015
Rated 5.0 out of 5.0 by miketheplumber hole hog drill
Works great.A strong,powerful,drill!Gets the job done.
March 26, 2015
Rated 5.0 out of 5.0 by MacinColorado Love my hawg
Nothing, I mean nothing can compare to a Milwaukee Hole Hawg for making holes in floor joists, or wall studs for running pipe or conduit. The right amount of torque, the right angle combined with the short body let it fit just about anywhere. Use a Milwaukee Switchblade self drilling bit and BAM you're good to go. I love my Hawg. Should have bought the case though.
May 6, 2014
Rated 5.0 out of 5.0 by MrMachine Just what I needed
If your going to drill a lot of holes for electrical & plumbing this is just what you need. Has all the torque you can handel without a clutch. Have respect for the power and use both hands or it will twist you into a pretzel.
September 2, 2014
Rated 5.0 out of 5.0 by Commercial1 Nothing does the job of a HAWG
Built for purpose, the Milwaukee Hole HAWG has the power and compact design to make the task of fishing between studs less of a challenge than it would appear. The two speed gearbox and long side grip keep all of the power under control while the carry handle and light weight (for the power) make it easy to make a full day. If you're in the business then you either own one or need to purchase one.
February 18, 2014
Rated 3.0 out of 5.0 by Plumb Be careful!
Let me start by saying I am a plumber and I need to drill big holes for PVC. This drill is a power house! no doubt about that. I will not use this drill for holes with a self feed bit that are over 2 1/8'' though. It doesn't have any clutch to slow down the drill so if it binds up on a knot or a nail, it WILL send you flying. For everything smaller, I love it. For larger holes I use the Milwaukee Super Hawg. This is an ideal drill for electricians
July 21, 2009
Rated 2.0 out of 5.0 by M Newer isn't better
Had a older Hole Hawg for years and abused it. I mean really abused it. I use it to spin a heavy cable up to 200' long. Finally fried it, new brushes wouldn't help so I bought a new one. Subtle changes, but the biggest is they use a new chuck from Jacobs. IT WON'T HOLD THE BIT. Used my channel locks on on the chuck key but constantly slipped and threw the adapter I had in place. Took it back and for now I'm using a cheap big box drill that works fine. What a shame.
October 24, 2014