Rated 3.4 out of 5 by 7
Rated 5.0 out of 5.0 by Trish MASTIC REMOVER IS OUTSTANDING!
ONCE YOU APPLY THE MASTIC REMOVER TO YOUR FLOOR AND ALLOW IT TO WORK, IT DOES ITS JOB. IT IS AN OUTSTANDING PRODUCT! ONCE YOU ALLOW IT TO PENETRATE, THERES LITTLE EFFORT ON YOUR PART TO REMOVE THE GLUE OR MASTIC FROM YOUR FLOOR.
THE CLEAN UP TAKES LITTLE TIME AS WELL.
March 19, 2013
Rated 4.0 out of 5.0 by Dion Works, though some elbow grease still required
We used Ready Strip to remove carpet adhesive from our basement floor. The previous owners had glued indoor-outdoor carpet to the entire floor, wall-to-wall. When we pulled up the carpet, it left a thick (1/16") layer of dried, flaky yellow adhesive behind. Our basement is cool and dry. The floor is not pefect. There are lots of pits and trowel marks.
Ready Strip generally worked as advertized, per the instructions. Here are some additional helpful hints that we learned by trial an error.
First, believe the 100 square foot rule. If you try to spead it thinner than that, it will not work as well. I used a paint roller, which remained moist in a ziplock bag between uses. The consistency is like thick, gelatinous chocolate pudding. When you spread it, you should leave it thick enough that you can see the tan color just a little bit. This will ensure that it has enough "power" to get all the way down to concrete through the adhesive. Also, it will "wet" the old adhesive so you can see where you missed.
Let it work the required 3-4 hours. Overnight seemed too long as it did not scrape up as easily.
We used a long-handled 12" scraper, which rolled the adhesive up in sheets where the floor was smooth underneath. It did not scrape up effortlessly, and applying more Ready Strip did not seem to help. One application, if thick enough, is as good as it gets.
The remaning adhesive, though, was soft all the way to the concrete. We found the best way to get the rest of it up was with heavy duty Scotch Brite pads and hot (almost too hot to touch) water. You don't have to scrub hard. Just scuff it over the surface and the remaining adhesive will roll up like rubber cement. Rinse the Scotch Brite pad often and change the water when it begins to cool. You will know because it will not work as well.
We tried several detergents, but nothing worked better than plain old hot water.
Scrubbing will leave a slick tan slurry which mops up easily. We mopped a couple of times just to make sure we got everything. I can't feel any residue, but I haven't tried to put anything new down (certainly not more indoor-outdoor carpet!), so I don't know how well things will stick to the clean floor. And I don't plan to find out for a long, long time.
July 1, 2012
Rated 4.0 out of 5.0 by basementflood Needed to get carpet glue off of my basement floor
After much research this item seemed to fit the bill. I purchased it and found it worked great. You need to put it down and leave it for a few hours, not too many though. The package said something about 12 to 24 hours. That was too long as it dried out! 2-3 hours seemed to work best. It stinks a little but I opened up my basement windows and that helped air it out. Once we scraped up the glue we put down warm water and scraped up more glue and mastic remover. Threw some sawdust down to help sop up the mess and it was done!
November 25, 2011
Rated 4.0 out of 5.0 by BeadGirl Don't need to wear a respirator
After trying acid, a power washer, and a brand of adhesive remover, to remove layers of old outdoor carpet glue from my patio with little success, I talked to a chemist friend. She looked online and suggested this product because of the ingredients. The product worked great on the thinner layers. For the thicker layers I had to let it sit much longer, which I was okay with, it was doing the job. Well, a pop-up shower came along and I was concerned the product was washed away and I would need to buy more. Over the rest of the summer and fall, I noticed over time, more of the thicker layers broke down. So, I am pleased with the prodct. If you buy it, really pay attention to the weather, or be patient and let time help. I was happy I did not need to wear a respirator like with other products I tried.
February 13, 2010
Rated 5.0 out of 5.0 by 1stremodel38 Works Great
I took 30 year old ceramic tile off my bathroom wall and found this ugly brown looking glue all over the wall. I could not get it off. I tried sanding to no avail. I searched the internet for something and found Ready Strip. It was wonderful. All you do is cover the wall and wait 24 hours and then it just scrapes right off. It was so easy!
December 10, 2011
Rated 1.0 out of 5.0 by PAPA Don't waste your time or money
followed instructions and product would not loosen mastic
August 15, 2012
Rated 1.0 out of 5.0 by Karen Waste of Money
I have 40 year old Black Mastik on my bathroom floor. Do Not Waste You Time On the Product..Waste of Money too!
August 17, 2013