Rated 4.6 out of 5 by 52
Rated 5.0 out of 5.0 by GoVols Weedeater primer bowl
Easy to install. worked the first time. great deal.
August 16, 2016
Rated 5.0 out of 5.0 by RayM Easy replacement, works great.
These primer bulbs are easy to replace on string trimmers, and save you money doing it yourself.
June 28, 2016
Rated 4.0 out of 5.0 by HawaiiGardener Just what I wanted
Just what I needed but I didn't need all the other sizes in the package.
March 29, 2016
Rated 5.0 out of 5.0 by Stefano Good
Fits my old edger and easy to replace.
you can use the main one to use on top until you replace the main bubble
December 8, 2015
Rated 5.0 out of 5.0 by ToolmanJr Cost and time saver
Troy Bilt Back Pack Blower TB2BP EC. Putting it away one day I nicked the primer bulb. Searched and found similar item on line that would have been twice the price. Searched Home Depot and found this in stock at my local store. Repair done in about 5 minutes and works fine. Yes, I have 2 left over. But compared to people trying to sell me an entire carburetor...this was a steal, And, it looks like one of the two I did not use will fit my Ryobi line trimmer.
July 1, 2015
Rated 3.0 out of 5.0 by Radakiss Why do I have to get all three?
The other two have gone to waste, but the one went in very quickly and soon after my weed whacker was running again. The tune up kit I bought last year had the wrong bulb in the kit forcing me to get this kit too. Oh well at least I didn't have to buy a whole new weed whacker
July 30, 2015
Rated 4.0 out of 5.0 by Grumpa I wasn't sure but it had everything I needed.
This kit has three sizes of bulb and I wasn't sure of the size I needed but it had it. The only down side is that I have the extra two sizes that I am not sure with what to do. Anyway my off brand trimmer is back up and whacking weeds.
August 4, 2015
Rated 4.0 out of 5.0 by ccjden Homelite weed eater primer bulb replacement
I replaced a primer bulb on my almost 30 year old Homelite weed eater, there are three assorted primer bulbs in the package, the one that fit was a little thicker at the base rim then the OEM part but not to bad and I was able to draw it flush when tightening the 4 screws at the four corners.
July 7, 2015