Questions and Answers for Gutter Guard by Gutterglove 4 ft. L x 6 in. W Stainless Steel Micro-Mesh Gutter Guard (40 ft. Kit)

A:  Hi Trey! About 99% of the time the small roof sand grit will not clog the mesh. You can have challenges with inside miters (inside gutter corners) where there is high accumulation of small debris and rainwater that congregate at the bottom of the roof valley. These areas will need to be brushed off from time to time. In the straight runs of gutter, generally speaking, when the rain drops come down, they splash the roof sand grit off. There will always be a little grit there in that front trough, but it cycles off the mesh, over the gutter and onto the ground and is replaced by other grit coming down the roof.

A:  Hi Kevin! We are sorry to hear about the situation you're having. Would it be possible for you to send us pictures of the gutter guards and the situation you're describing and email it to customerservice@gutterglove.com in that way we can have a look and help you out. You can also call us at 877-662-5644.

A:  Yes, self tapping screws are included in the kit.

A:  About 99% of the time the small dirt will not clog the mesh. You can have challenges with inside miters (inside gutter corners) where there is high accumulation of small debris and rainwater that congregate at the bottom of the roof valley. These areas will need to be brushed off from time to time. A great way to clean off your gutter guard is with the use of The Gutter Guard Brush. It’s designed to clean off any gutter guard without having to get on a ladder or roof. You just screw this special brush on the end of any standard extension pole, then from the ground, just reach up and brush it off.

A:  Hi JustinTime! We use a 30mesh (that is 30×30 holes/square inch) which is more effective than smaller hole sizes at keeping out debris.

A:  Hi Streeter! Yes, the gutter guards can be installed on gutters with hangers. For a more detailed recommendation on how to do the installation you can send us pictures of your gutter to roof system to customerservice@gutterglove.com.

A:  Hi Kevin! Thank you for reaching out to us. For gutters between 2.5" to 5" wide we recommend the 5" version of the gutter guards which measures 5.5". As long as you retain between a 5 and 25 degree of angle or 1/12 to 6/12 pitch on the gutter guard once installed and ensure you have the front edge of our gutter guard lay flat on the front edge of your gutter, then you should achieve optimal performance.

A:  The wire mesh part can but for the metal rail I used a multitool/oscillating tool with a metal blade. The snips were too difficult as some parts of the metal rail are built like a T.

A:  Hi Cindy! You can determine the width of your gutter by measuring from the back, top edge where your house meets your gutter to the very front outside lip of your gutter. If your gutter is 5" wide or less, you will need our Standard 5" version. If your gutter is anything over 5" wide up to 7" wide, you will need our Super 6" version.

A:  Hi Robert! Our gutter guard works on any type of gutter to roof system. For a detailed recommendation on how to install the gutter guards please safely take a picture of your gutter to roof system that is parallel to the ground and send it to customerservice@gutterglove.com. Thank you!