A: I’m wondering when my other 11 brushes are going to arrive. I bought these because it was a screaming deal on 12 brushes. I have only received one. And it looks like I’m not the only person to point out the quantity 12 pack. They should honor it.
A: These cost around $4 each. I don’t know what price is quoted
A: Single brush.
A: Yes. You can use with any type of paint.
A: Yes it can be used with oil Based Paint. It has a edge on it so you do not have to put tape up. I love this brush. Over the past 6 years I can say I have bought 20+ Brushes! Love this Brush
A: Yes it can be used in an oil based paint or stain, but we would recommend using the Wooster Pro White China Bristle line of brushes when it comes to oil-based coatings. With the White China Bristle, it is natural hog hair that will penetrant the thin oil coatings easier. The natural split end hair with hold the oil-based coating better. If any further assistants is needed we welcome calls to Wooster Brush customer service at (800) 392-7246.
A: You need to read the cover on the brush - it will tell you which types of paint the brush works with best. There is one of these short brushes that is good with all types of paints.
A: yes it is meant for all paints
A: The reason the paint sticks is because you are letting it get dry. To avoid that, I pour the paint that I plan to use into a small plastic bucket (size = 1.625 quarts) that has a cover. If I decide to take a break or decide to stop painting until the next day, I immediately close the bucket with the brush inside to keep it from getting dry. After I'm done painting, I pour the excess paint back into the container and immediately wash the brush and the small bucket with plenty of cold water. Any stuck paint will come off easily with little scrubbing.
A: Yes I felt the same way, cleaning upper portion consumed a lot of water. I used a hose and cleaned in my lawn.
A: I did not find any problems.
A: Soak it in water or nail paint remover
A: If you put the brush directly under flowing water, squeeze the brush repeatedly until the waster clears. Use a wire brush to comb the bristles to remove as much paint as possible and prep the brush for tne next time.
A: Depending on the coating that the brush was used in there can be helpful ways to clean the brushes out. a Big helper when cleaning a brush is using our brush comb (#310277053). If the brush was used in an oil based coating we recommend using mineral spirits to clean out the brush. If the brush was used in a water based coating the recommended cleaning method is using warm soapy water working it in the bristle with your hands to get paint loosed up and coming out. Also using the brush comb in either method using the metal tines to really get in between the bristles and get as much of the paint further up in the brush out. After that switching over to the brass bristle side of the comb to get any last paint out of the brush. Let the water run clear so you know you have everything out and the big thing is to hang the brush to dry so it has the ability to drain any excess out. Also a big thing with todays coatings is that they are very thick and dry times on them are very fast so when cleaning you need to do it immediately after finishing painting so they brush does not harden.
A: Unfortunately, this is where paint has dried in the upper bristles as you have been painting. It is not an issue that is resolved with a different brush, it takes a solvent to break down the dried paint. Soap and water are for cleaning dirt and grime, not paint.
A: I use dawn liquid and all the paint comes out just fine. Use an old toothbrush and just brush down so you don't ruin the bristles and all the paint will come off
A: Did you dampen your brush prior to using?
A: I always soak the brush in a glass of water after the initial rinse out. I use a small wire brush to comb the outsides going with the brush hairs. After I let it soak I turn the brush upside down and run water through it. I then soak it again for a bit. Then I rinse one last time and stand on a paper towel in a sunny window and let it dry. I find this method is pretty easy even though it has several steps and makes these brushes last and last. I love the brush and if you are getting paint up in the brush while you work you have to get it out or the brush is short lived.
A: Yes it can be
A: Yes.
A: I am not sure as I just use soap and water and they come clean
A: I cleaned mine with soap and water
A: Yes
A: Yes. I usually use latex paint so clean with soap and water but paint thinner can be used.
A: Never have since I use latex, so not sure how the glue would hold up, but they are inexpensive enough to test.
A: Yes, as long as you are cleaning an oil-based liquid out of the brush. If you used a water-based liquid/coating with the brush and use thinner it can gum up the brush. Always read the back of the can of your coating, it will tell you what to use to clean up. (Yes, the filaments/bristles of the brush can withstand thinner.)
A: Yes, and with soap & water and mineral spirits.
A: depends on the type of paint you are using. Check the paint manufacturers recommendation and cleaning solution. When I have thick paint or a brush that has not dried all the way, I soak it in the natural paint remover (orange stuff) available at Home Depot, before i clean it with paper towels and soap and water.
A: Yes it can. The price point of this brush makes it tempting to use as a disposable brush too.
A: I purchased mine to use with a stain and it worked beautifully. Nice and even.
A: This is a high performance brush and can be used over and over. The label says you can use it for all paints. That said, you should be able to use this brush for your purpose, but I would suggest that you save this one for projects that will allow you to clean the brush and use it again. You might want to use an economy brush that you could throw away after use with the metal primer. This brush is fantastic for all uses, but is especially great for cutting in.
A: Typically, the best type of brush for oil based paints/primers is a natural-bristle brush. They'll typically cost more than a polyester synthetic brush, but the results will be better and the brush will sustain multiple cleaning/re-use cycles. I find that these Wooster Sash brushes get very heavy and limp with oil based paints.
A: Yes.
A: Yes, it can and it leaves a reasonably smooth finish; better than the low end brushes that leave a lot of bristles behind but just below the high end Purdy brushes that provide a smoother finish. Keep the leading edge of the oil wet; do not drybrush previously painted surfaces until the recommended dry time between coats has completed drying. Be patient. Oil finishes take a fair amount of time to dry and if you put on too much paint the surface can run or droop. The finish will feel slightly tacky even after drying. Oil finishes can take weeks to fully cure (outgas) but you will end up with a durable finish that will be way more durable than an acrylic paint.
A: It Can just has to be cleaned differently using a turpentine
A: Yes, this Shortcut brush will work well with your oil-based metal primer.
A: It's possible to paint with Anyting but No, i don't recommend using it for oil based metal primer. It will hold too much paint causing a mess.
A: Both any paint brand
A: IDK
A: "Made in USA - with global ingredients". You know what that means. Regardless, these are my go-to brushes, hands down.
A: U.S.A. I think Wooster, Ohio.
A: It is made in Ohio, USA!!!
A: The Wooster Brush Company was established in 1851 and is one of the oldest manufacturers of paint applicators in the USA.
A: By WOOSTER. READ MOMO!
A: I believe it's made in Wooster Ohio
A: There are 2 places in the US where these are made, Nevada is one the other slips my mind other than being able to say it's within an area of Nevada some place North of it.
A: Made in USA.
A: Made in Wooster, Ohio at The Wooster Brush Company.
A: Yes it is a gr8 brush for any paint
A: Yes it does well with chalk paint Very little brush marks
A: I have not used it on chalk paint so I can't really say it worked so well I would think so.
A: Yes. Always dip then wipe one side of brush tip before applying paint to walls. Wait for 1st coat to completely dry before attempting top coat or else you will see brush strokes.
A: .
A: Yes, it works great with chalk paint. Make sure to wash it out thoroughly soon after job so you can use it again and again. I hope this helps...
A: YES! It will definitely get the paint job done. If your not a master at cutting in then may I suggest taping ALL surfaces you don't want paint on.
A: Yes, it works with all kinds of paint.
A: According to information on best brushes..this brush can be used with chalk paint..but you should read information from manufacturer to be sure and on the paint can also.
A: Yes you can! Just make sure you sand down the surface you want to paint first.
A: While I have never used chalk paint, this brush was recommended to me by the owner of a paint store a while back. Since then, I have purchased a few of these and love them! They are great quality and easy to hold which makes cutting in very easy.
A: Yes, it works great with chalk paint. Make sure to wash it out thoroughly soon after job so you can use it again and again. I hope this helps...
A: I have never tried it with chalk paint but works well with flat and eggshell paints
A: Yes I bought it for that! It worked wonderfully.
A: The Shortcut can be used with all paint, including chalk paint. We always recommend checking the coating for the best suited applicator; however, many painters love the Shortcut for this type of project. We also always welcome calls to Wooster Customer Service at 800-392-7246 should you need help choosing the perfect applicator for your project.
A: I don’t know how many five start ratings it has, but I love these brushes. They are the only brushes I use!
A: Not sure but I would give it a five. It is very versatile for any job. I usually buy a few for spares even though they clean up like new.
A: 5 stars. These brushes are the best, especially when painting around trim or in my case, a tile mural.
A: That will vary with time. However, if you hover the mouse cursor over the rating number on the product page (without clicking on the ratings) it will show you the ratings breakdown. Also, you can scroll to the "Customer Reviews" section which will show you the same breakdown. I hope this helps!
A: At the current time, the Wooster Shortcut rates at 4.8 stars, meaning 97% of those providing a review would recommend this product. This is out of 2,579 reviews. This is subject to change over time.
A: Sure
A: Yes, this brush is designed to be used with all stains and paints. Sealers can be applied with any style of brush. However, depending upon the size of your project, you might be well advised to use a larger brush, with greater brush capacity.
A: Maybe yes
A: This brush can be used for both of yor needs. Be advised with proper cleaning after each use this brush will last for multiple usages This is a fine product that is comfortable to use as opposed to larger more cumbersome brushes.
A: Yes, the Shortcut polyester can be used with oil-based stains. Many painters like to use a natural bristle with oil-based stains. We also offer the Shortcut in a natural white bristle (see product #204318245). Check your stain for application instructions to find which option may work the best for you.
current item | |||
Brush Head Material | |||
---|---|---|---|
Polyester | Polyester | Polyester | |
Brush Type | |||
Sash Brush | Sash Brush | ||
Wall Types | |||
All wall types | All wall types | Rough | |
Package Quantity | |||
1 | 1 | ||
Applicator/Tool Type | |||
Brush | Caulk Tool/Accessory | Brush | Multisize Brush Pack |
How can we help?