Customer Reviews for Colmet 4 ft. 14-Gauge Pre-curved Brown Steel Tree Ring Section

Rating provided by a verified purchaser

wish the connector tabs lined up a littlle better , but this is still the best way to go !Wish i had a lot more of these and more 8 ft straight pieces !

easy to use for 3 ft circle have to reform to make 6 ft circle

This was a relatively easy and cost efficient solution to creating a 5' diameter ring around my 2 trees. It's not a terrific solution because it will rust out in a few years and will need to be replaced.

We replaced our fiberglass edging with steel. This is a 2 person job. A trench needs to be dug before you set the new edging in place. Removing the anchor spikes takes 2 pliers. The wide stakes also help. The finished job looks great.

Had to notch a few places to clear roots at ground level, but overall, the installation was a breeze, and it looks good.

Works great and pre bend is very helpful!

Rating provided by a verified purchaser

Work well but it is impossible to remove stakes from the straight versions. I had to use other things to place them.

Heavy duty easy to install with only a rubber mallet.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Steel tree ring is a good product so far. If it doesn't peel it's paint, I will be even more.pleased. Its related product, 8.5' lengths, were in our landscaping approximately 5 years. Much of the brown paint peeled off.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

This is a great substitute for resin Benda Board. Engineered to fit reasonably well and the flat metal stakes seem to be just long enough to make it secure in the ground

Great rust protection.

Nice looking installed. Clean lines since it’s thin (but strong). I used the stakes that came with it but Home Depot also sells 12” stakes (same brand, right next to these) that you can use with these if you need them.

Wanted to rehabilitate several heat-stressed cholla cacti in the yard. After installing three Tree Ring Sections per plant, they have responded favorably from the additional watering, nutrients and mulching to reduce heat exposure and improve moisture retention. In the last several days, they have begun to display many great purple flowers. Happy with the results!

Very easy to install and they look great. They appear as if they will last a long time- heavy gauge and well painted. Time will tell. The claw end of a hammer makes short work of separating the stakes. Took less than 10 seconds.

Great product, easy to work with if you want instant sturdy edging. I give it 4 stars because the painted surfaces don't hold up on install or normal wear and tear. Then it looks like a tacky twisted piece of metal.

Excellent, very well made

Does the job, easy to install and like the color. Will save my tree from the lawn maintenance people!

We installed about 200 feet of the straight edging. Got enough of this to ring around two trees. The product is strong enough to mostly maintain it's curve. The trick to making a circle is to approximate the radius and measure out from the tree. Connect all but one piece slightly together and use the radius as the starting point to stake the middle piece in the ground (just enough to hold). Then attach the last section. Took us a few tries till we goth this method. The second tree went very fast after that.

This seems to be a good durable product but it is not self explanatory. The little yellow sticker with a pic of where to put the stakes isn't enough.