Customer Reviews for DIABLO 10 in. x 60-Teeth Fine Finish Saw Blade
- Compatible with 10" miter saws, slide miter saws, & table saws
- Cuts plywood, melamine, MDF, hard & soft woods
- Little to no sanding rework required
Customer Reviews
May 19, 2020
This is not the cheapest saw you'll find, but having tried others it is worth the money. So far I...
This is not the cheapest saw you'll find, but having tried others it is worth the money. So far I have had no burn marks, using on 3/4 Birch plywood. It cuts a very smooth line with no splinters on the bottom edge (you will always get some on the top edge but it's really minimal).
This fit perfectly on craftsman miter saw.
by Minty1
Apr 25, 2019
First thing I do when I get a new saw is to install a new Diablo blade. I know there are more exp...
First thing I do when I get a new saw is to install a new Diablo blade. I know there are more expensive blades out there, but so far Diablo blades have never let me down. This blade was for my new table saw. I use a lot of plywood in my work and need as clean of cuts as I can, but also need a blade that can handle cross cuts on hardwoods as well. This blade does not disappoint, great cuts! This is a very reasonable priced blade that can be used for most your needs. I prefer fewer teeth for rip cuts, but I have done some with this blade and it held up pretty good there too.
by txgent10
Mar 12, 2019
When compared to the factory blade that came with my table saw. This one cuts so much better with...
When compared to the factory blade that came with my table saw. This one cuts so much better with way less splintering. I also purchased them for my miter saw and circular saw.
by Papabearcraft
May 21, 2018
Best bang for the buck!!
I have a Delta table saw and have been using the factory blade for 6 months. As a wood worker, my products can be ruined by one bad cut. My Delta blade wasnt cutting like I needed and upgraded to the Diablo 60 tooth blade after reading all the positive reviews. might and day difference! cut fast and smooth with no tear out at all.
by American
Apr 13, 2017
I have the same blade that I have been using for about three years and it gets used almost daily....
I have the same blade that I have been using for about three years and it gets used almost daily. The cuts are always smooth with no tear out. I cut from pine, zebra wood, cherry, maple, olive, oak, poplar, mora and many more with no issues at all. These blades may cost more but they are well worth it in the long run. You won't be disappointed
by Picasso