DEWALT continues to design and optimize professional jobsite solutions for the toughest jobsite conditions.
Compatible with hammer drills and drill drivers.
Prevent rust and wear with black and gold oxide coating.
135 degree split point tip design to help reduce walking.
High Speed Steel to be used in plastic, wood and metal.
3-flats shank to reduce spin-out in chuck. 3-flats on sizes larger than 3/16 in.
For use in hammer drills and drill drivers.
Includes sizes 1/16 in. through 1/2 in.
12 in. bits include sizes 1/8 in. through 1/2 in.
Includes 1/2 in., 5/8 in. and 9/16 in. sizes.
Ideal for use in wood.
Ideal for use in metal at slower speeds.
Ideal for use in plastics and fiberglass.
Yes it will.
It is 6" long.
6 inches tip to end of shank.
No the bit will just fit. It fit my Dewalt.
If you're smart you will drill at least one pilot hole.
Slowly with lots of oil
Not what I would use on that, although it will work to "make a hole". You'll probably get a lot of tear-out with a twist bit. I'd go with a forstner bit or a spade bit with the "outer ears" that will cut the circumference cleanly first
not all drills are carried in all store try online frist to see if they have it