Camelot Aged Bronze Single Cylinder Deadbolt with Accent Entry Door Handle Combo Pack

Used for a rear entry door purchased and installed from Home Depot. I did the installation and it was easy. Finished product looks great. Had both locks keyed to our own key pattern at the Home Depot store for a small fee. Excellent customer service.

Very nice looking handle and lock, but DO NOT buy the bronze. Less than one year and the finish came off of the outside pieces. Looks horrible!

Works and looks great! Thanks!

This lock and handle combination works flawlessly and accents the door very well

My whole house from front and back doors and bathrooms to bedrooms doors all have been installed with the handle or lock we just absolutely love the look and quality.

Beautiful looks and smooth locking. Very nice and easy to use.

Great product, works and looks like a charm! A lot more sturdy and secure feeling than the Kwikset door set I had.

Nice door hardware can be very expensive and this exterior door lever/deadbolt combo has great fit and finish at a great price point. I'm a housewife learning to do stuff around the house and I was able to install this in 15 minutes. I skipped the directions and unpacked the hardware and did a practice assembly to see how the unit worked before installing it on the door. I had two minor problems due to the sloppy installation of the original hardware - first, the deadbolt was too low so this meant the back plate of the deadbolt touched the back plate for the door lever when there should have been a gap; and second, the old deadbolt faceplate was installed incorrectly so the new faceplate wouldn't fit and I had to use the curved faceplate meant for the door lever. Minor details but annoying and I had to maneuver the hardware to make it fit. TIP: Because the back plate is rectangular, before you completely tighten down the screws on the deadbolt and door lever, be sure to align the plates to each other as well as to check that they're straight up and down to avoid marring the door finish. hmmm, I was able to install the hardware but can't figure out how to make the photo view properly . . .

I was replacing an existing lockset, so didn't have very much problem at all installing this one; however, when I had questions I found the instructions to be meager and confusing, written on multiple small papers each with multiple languages. Fortunately, there were no real concerns so everything went well. One thing I noticed is that due to design the handle unlocks itself when opened; I was told this was because it allows easy and fast evacuation from a home, and that makes sense. However, if I have my grandkids in the house, that means they can unlock the door easily if the deadbolt isn't also engaged. I installed this on a back patio door and wish there were a way to select which way that lock worked. Good things include very nice fit and finish, good, strong bolts to mount the strike plate onto the doorframe; the whole assembly feels very well constructed and I anticipate long life from it. I didn't need to do so, but was impressed that you can switch the handle directions quite easily, if those directions are accurate. I both liked and disliked the fact that the mounting screws show from the inside; it would have been nice to have some sort of esthetic plug to cover them, but then those often are flimsy and don't look good after a few years. Possible weaknesses include that the lock activator bar (inside the door, extending from one side to the other of the lock) seems a little flimsy; my previous lock had one about 1/2 inch wide and at least 1/4 inch thick; in this lock it's about 1/4 by 1/8, but I don't know that it will ever be strained enough to matter. And, again, the instructions seem quite limited and don't reflect the actual appearance of some internal components, causing some confusion. The lockset is very well packaged--almost too well, and you have to make sure to get some of the pieces out of close-tolerance areas in cardboard. Eco friendly? Probably not, but very secure, so the finish stays looking great. Just make sure the outside deadbolt beveled ring for selecting small vs large bore holes--which doesn't look a thing like it shows in the instructions--doesn't get forgotten. I thought I'd have to take it back to HD, but then found it sunken in a shallow circular hole in the thick cardboard. A little pricy as well, but I've always believed you get what you pay for; hope I'm satisfied for many, many years.