Questions and Answers for BEHR PREMIUM 1 gal. #PFC-42 Flintridge Solid Color Flat Interior/Exterior Concrete Stain

A:  Hi Larry, thank you for your question. The Solid Concrete Stain has a flat finish, however, the surface can become slippery when wet. Have a great day! -Giovanna

A:  Hi Maria, thank you for your question. After etching and rinsing off your concrete, allow it to dry completely. This can take about 24 hours. Good luck with your project! -Giovanna

A:  Hi Sandra, thank you for your question. The Solid Color Concrete Stain can be custom color-matched to a sample of the foundation brick color. Before applying, ensure the surface is cleaned, etched, dry, and primed using a product such as our Concrete Bonding Primer No. 880, for best results. Have a great day! - Randy

A:  Hi JetGray, thank you for your question. Jet Gray PFC-82 can be tinted in our concrete and wood floor coatings. Have a great day! - Randy

A:  Hi Lori, thank you for your question. After allowing the mortar to cure, you can prime the surface before staining. Assuming this is a floor, we recommend using our Concrete Bonding Primer No. 880 before staining. You can use a 1/4-3/8” nap roller cover, pad applicator, or nylon/polyester brush. Good luck with your project! -Giovanna

A:  Hi, thank you for your question. Yes, you can use a power washer at a low setting to clean the surface without issues. Have a great day! -Alex

A:  Hi Trichard981, thank you for your question. The Solid Concrete Stain can be used over a previously painted surface in good condition. You do not need to use a primer, but the surface should be sound, clean, and dry before applying. Also, if the previous finish is glossy, scuff sand the surface to promote adhesion. Good luck with your project! -Giovanna

A:  Hi Kumkum, thank you for your question. I'm sorry to hear about the issues with the worms. That's not normal, and we'd like to learn more about your project. Please reach out to us directly so that we can learn more details about your project and find the best way to help. We look forward to hearing from you! -Giovanna

A:  Hi hankstar, thanks for your question. You do not need to prime your previously stained patio surface, provided there is no peeling/bubbling or bare concrete showing. Just fill any hairline cracks and ensure the surface is clean before applying our Solid Color Concrete Stain. Good luck with your project! -Christina

A:  Hi Anthony, thank you for your question. The Solid Color Concrete Stain can be applied to vertical masonry surfaces once the surface has been primed using the Multi-Surface Primer and Sealer No. 436, as the Concrete Bonding Primer isn't recommended on vertical surfaces. Have a great day! - Randy