A: No, it is not noisy. The fan operates at approximately 4 sones plus more due to the variable speed.
by|May 6, 2020
A: It is rated at 4.5 sones so it is moderately loud.
by|May 17, 2022
Q:Does it have to be hard wired or can it be plugged in?
by|Aug 19, 2019
2 Answers
Answer This Question
A: This unit has to have electric run to a built-in receptacle. The motor is a lifetime lubricated, thermally protected, plug-in motor.
by|Mar 26, 2020
A: I is designed to be hard wired.
by|Mar 26, 2020
1 found this answer helpful
Q:Does this fan have a screen to stop bugs comeing in?
by|May 8, 2019
2 Answers
Answer This Question
A: Yes, this fan has a screen to stop bugs that's coming in
by|May 9, 2019
A: This is a room to room fan. It is not ducted to the outside. It does not have a screen.
by|May 9, 2019
Q:How noisy is the Broan 389 Fan? As I’m looking to install it in a bedroom.
by|Apr 9, 2019
1 Answer
Answer This Question
A: The 510 room-to-room fan operates at 380 CFM, 6.5 sones at full power. However, it does have a solid state speed control for fan speed and sound level selection.
by|Apr 10, 2019
Q:Can the direction of flow be reversed to push air into the room. I am looking to heat a non-heater room by attaching this to an existing duct to heat the room.
by|Feb 13, 2019
1 Answer
Answer This Question
A: The direction of air flow cannot be reversed.
by|Feb 13, 2019
Q:what is the diameter of the hole needed through the wall? Can it be cut with a hole saw?
by|Jan 19, 2019
3 Answers
Answer This Question
A: you have to plan where you going to put the fan the fan has to go between the studs and four inches down from the ceiling so you clear the double sill plate at the top you can cut the hole with a sheetrock saw and it should so very easily it's an 8in diameter hole or eight and a half inch diameter hole very good fan I've had them in the house for years
by|Jan 19, 2019
A: It is 6" in diameter. For installation assistance, please contact our Technical Support Department at 800-637-1453.
by|Jan 21, 2019
A: It's six inches in diameter, but to be certain just lean it against the wall and trace it.
The easiest way to cut the wallboard to size is by hand with a wallboard saw, which is a LOT cheaper than a 6" hole saw. A sabre saw will work, too,
by|Jan 19, 2019
Q:What on / off switch - speed controller is recommended for this fan?
by|Jun 19, 2018
2 Answers
Answer This Question
A: We recommend our switch, model no 57W (white) or 57V (ivory). This is a variable speed control suitable for 120V, 3 AMPs. Thank you.
by|May 5, 2023
A: Model 57W or 57V is recommended.
by|May 5, 2023
Q:Does it blow in and out?
by|Jan 7, 2018
6 Answers
Answer This Question
A: No, it only blows in one direction.
by|May 5, 2023
A: No. One direction only
by|May 5, 2023
A: No, this fan only acts as an exhaust and blows a single direction.
by|May 5, 2023
A: It blows in only one direction
by|May 5, 2023
A: This fan pulls from one direction
For instance if you are trying to pull heat from one room to another
by|May 5, 2023
A: It blows out. I have it installed above my bathroom door to (especially now with the heat being on all the time) blow out the warm, moist air to the rest of the house.
A little loud, but it only takes a few minutes to exhaust the moist air.
by|May 5, 2023
1 found this answer helpful
Q:Hello, Is this fan Compatible with Mercury Nutone M 830 Fan model?
by|Dec 19, 2017
1 Answer
Answer This Question
A: The M830 was not a room-to-room fans as the 512. You may want to view models 502 or 503. You may want to contact our Technical Support Department at 888-336-6151. Thank you.
by|May 5, 2023
1 found this answer helpful
Q:Can i connect ducting to each side so it will reach through a thicker wall?
by|Nov 25, 2017
2 Answers
Answer This Question
A: yes
by|May 5, 2023
A: This model is designed for walls that 4-12" - 5-1/8" thick. We would not recommend that you alter the housing for a thicker wall. To get additional information please contact our Technical Support Department at 888-336-6151. Thank you.