Questions and Answers for Cap A Tread Heirloom Pine 47 in. L x 12.15 in. W x 1.69 in. T Vinyl Stair Tread Cover Adhesive

A:  Patrick, Thank you for your interest in Zamma stair renewal system. The kits are priced per kit (1 cap-a-tread and 1 riser) and packaged up to 2 per carton for shipment. Best of luck with your stair project.

A:  Marlene, Thank you for your interest in Zamma Cap-A-Treads. We produce a cap-a-tread with a right return piece and a mitered edge on the cap-a-tread. You will need to place an out of catalog special order, in store using SKU#1000044780, Model# 016173693. If the store needs assistance placing the order they have the number to call us direct. Best of luck with your project.

A:  Thank you for your interest in Zamma Cap-A-Treads. This product is currently on back order. They should be available to order on-line in 1-2 weeks or you may place a special order in store, using SKU# 1000044780, Model# 016173693. Best of luck with your project.

A:  Thank you for your interest in Zamma cap-a-treads. They should be back in stock in about 2 weeks. You may place a special order in store SKU# 1000044780, Model# 016173693. Best of luck with your project.

A:  Thank you

A:  Thank you for your question. Unfortunately we do not produce a Type 2 Cap A Tread with a return piece. You will need to purchase an additional tread, cut and miter the bull nose off the front of the extra tread. Please e-mail us at customerservice@zamma.com so that we may e-mail an instruction sheet.

A:  Unfortunately the Type 2 is not produced in the 94" length. You will need to use the standard cap-a-tread Model# 016043693, then trim the bull nose that extends over the riser to 1", to accommodate the cap-a-tread.

A:  They are available to order on-line, Model # 016A73693.

A:  We produce this tread in a 94" length, model# 016043693. We show 11 in stock and should ship within a week of receiving the order.

A:  I believe you could get two and get them to seam tightly. This was super easy to install and I feel so long as the cut is clean the joint would not be obvious. I would put it 6" from the side that way it wouldn't be stepped on all the time as well. That's my Two Cents.

A:  Carefully cut the step to fit.