Select store
...
Cart
Shop All
Services
DIY
Me
by
A: The DW1606 G is manufactured in China.
A: The DW1614 G is rounded.
A: It is not recommended by the manufacturer DEWALT. You would need a bolt extractor set for maximum effectiveness on that job.
A: Maybe. If it’s only one or two. Bit burns out fast.
A: Yes, but don't expect much out of it afterward
A: The DW1112 3/16 in bit is for plastic.
A: Yes
A: Not what I bought it for but I imagine it would have no trouble at all. I used it on 4in. treated landscape timbers with no problems.
A: If it is not petrified! They are very tough. You may need to pull it out a few times as you drill to allow the shavings to fall off the flute.
A: It drills through wood very well, however, since the flutes don't do up the whole way you'll have to clear the chips out often.
A: yes it is a 3/8 drill bit
A: Yes, it will fit in a 3/8" chuck.
A: No it won't I bought it off these answers and it doesn't fit
A: This is a drill bit. It will work with corded drills.
A: Trust me. This DOES NOT fit a 3/8 drill. I purchased it today and NO GO.
A: No,only wood or mild steel.
A: No
A: Yes, I bought mine last week. but it was small for me and i was returned it. but personally i like very much all DEWALT.