Questions and Answers for Everbilt 1/8 in. Zinc-Plated Wire Rope Clamp (2-Pack)

A:  Everbilt 1/8 in. Zinc-Plated Wire Rope Clamp (2-Pack) has #10-24 nuts.

A:  We do not list a working load limit rating for these clips due to the variability in their use with wire ropes.

A:  They should work fine, just make sure you put the cable in the clamp right, the dead end of the cable should go on the clamp/nut side.

A:  It should be okay. I used mine to connect some 10 gauge wire and it worked.

A:  For the Everbilt 1/8 in. Zinc-Plated Wire Rope Clamp (2-Pack), the recommended method is to remove the coating so we recommend to use the Everbilt 1/8 in. x 75 ft. Galvanized Dog Run Cable Exerciser Kit, Internet #203958753, Model #803202, Store SKU #274954.

A:  Everbilt 1/8 in. Zinc-Plated Wire Rope Clamp (2-Pack) has a clamp thread size of #10-24.

A:  1/4 20

A:  Everbilt 1/8 in. Zinc-Plated Wire Rope Clamp is designed to work with 1/8" wire ropes. 1/2" braided rope will not work with this product.

A:  No…way too small….the 1/8th inch was the size of the SS cable….you need 1/2” clamps

A:  These would do the job...but you would have to use about 15 of them. They only accept 1/8" wire rope which I would never trust for that kind of loading.

A:  everyone here is wrong look at this chart

A:  We cannot recommend a particular rope clip because the working load limit rating for these clips depends on their use with wire ropes.

A:  7/16 steel rope has a working strength of 3300 pounds. Everbilt doesn't seem to have a working strength spec. BTW what does "2500 pounds or more" actually mean?

A:  Used it for my clothesline which is pretty long. I fill the line with wet clothes and it holds. I do have props for each line. How much weight I can't say.

A:  Home Depot says that 1/8 wire rope handles 340 pounds.

A:  We do not list a working load limit rating for these clips due to the variability in their use with wire ropes.