Q:I have a 240 volt, 100 amp breaker, dedicated outlet for a welder in my garage. It has the 3-prong dryer plug set up. 50 amps more than required is ok for this Lincoln welder? Wouldn't cause any issues?
by|Oct 10, 2023
1 Answer
Answer This Question
A: Should be more than adequate.
by|Jan 13, 2024
Q:Is there a 120V Lincoln Arc Welding machine available besides the 220v machine?
by|Feb 5, 2023
1 Answer
Answer This Question
A: Marco, Thank you for your recent inquiry with The Home Depot. There is not a 120v but here is one similar, just enter the model or internet number in the search bar.
Internet #305497567
Model #K2789-2
Store SKU #1003230606
We appreciate your business and look forward to serving you in the future.
by|Feb 16, 2023
Q:How long are the leads and what gauge are the wires?
220 power cord length also if anyone knows for sure, Thanks
by|Dec 19, 2022
0 Answer
Answer This Question
Q:What is difference in a Lincoln ac 225
And ac/dc 225
by|Nov 21, 2022
1 Answer
Answer This Question
A: A AC welder operates on alternating current (ac), while a AC/DC welder also can operate on DC ( direct current ). In my opinion the ac/dc is the way to go because you have more options, and in many cases you will want to use DC.
by|Aug 21, 2023
1 found this answer helpful
Q:How long are the leads?
by|Feb 16, 2022
1 Answer
Answer This Question
A: The leads are 10ft and 12ft.
by|Feb 17, 2022
Q:Why install a 50 amp breaker and #6 wire when the cord to the welder is 12-2 with ground. Why #12 all the way from panel
by|Sep 27, 2021
1 Answer
Answer This Question
A: Thank you for your recent inquiry with The Home Depot . Per the manufacture installation direction.
Using the following instructions, have a qualified electrician connect
this receptacle (NEMA 6-50R Type) to the power lines at the fuse
box. Three #10 or larger copper wires are required if conduit is
used. For long cable runs over 100'(31m), #8 or larger wire in
conduit will be needed to prevent excessive voltage drops. Fuse the
two hot lines with 50 ampere super lag type fuses as shown in the
following diagram. The center contact in the receptacle is for the
grounding connection. A green wire in the input cable connects this
contact to the frame of the welder. This insures proper grounding of
the welder frame when the welder plug is inserted into the
receptacle. If a separate disconnect switch is used, it should have
two poles for the two hot lines and both should be fused for 50
amperes. You may find the installation guide on the product page under "Product Overview" on the left side under " Info and Guides"
We appreciate your business and look forward to serving you in the future
by|Dec 3, 2023
2 found this answer helpful
Q:What is the price of a Lincoln Electric AC/CD ARC Welder AC/DC 225/125 23 Inches Length And 16 Inches Width?