A: I am not sure since the package it came with was thrown out and my husband just used the screws that came with it.
by|Jul 14, 2020
A: KPW, thank you for your question. These glides come with #8 x 3/4" inch screws.
by|Aug 28, 2019
Q:What is the height of the glide? The product description lists 5.5 - which can't be correct. A similar product in the 1.5 inch size listed the height/thickness as .375 inch. Are the 1 inch glides a similar thickness?
by|Nov 30, 2017
3 Answers
Answer This Question
A: these are approx 1/4" thick
by|Dec 13, 2019
1 found this answer helpful
A: the approx. height is 1/4"
by|May 5, 2023
A: Yes, they are a similar thickness. The 5.5" in the description is referring to the height of the package it comes in.
by|Dec 11, 2020
1 found this answer helpful
Q:The 1" Shepherd slider is shown as 8/pack. The cost is $5.26 "each". Does the $5.26 to each piece or each 8 pack??
by|Feb 12, 2017
3 Answers
Answer This Question
A: Each 8 pack. And eight screws are included
by|May 5, 2023
A: the cost is for the 8 pack
by|May 5, 2023
A: The cost is $5.26 for each 8-pack.
by|May 4, 2023
Q:Weight capacity is listed as 75 pounds. Can I use them on dining room chairs? When someone is sitting in the chair the weight will be more than 75 pou
by|Dec 17, 2015
2 Answers
Answer This Question
A: The weight capacity is 75 lbs per glide. If there are 4 legs on the chair, then 4 x 75 = 300 lbs.
by|May 3, 2023
2 found this answer helpful
A: the 75lbs. would be multiplied by the 4 chair legs. 4x75=300lbs.
by|Feb 18, 2019
1 found this answer helpful
Q:What size is the included screw and is it pointed or a flat srew?
by|Dec 21, 2014
4 Answers
Answer This Question
A: they are about 1" long 1/8" diameter and rounded head.
by|May 5, 2023
A: Hello, the screw is a #8 x ¾” long, phillips head or flat
by|Dec 11, 2020
3 found this answer helpful
A: THE SCREW IS POINTED AND ABOUT 3/4 INCH. I HAD NO TROUBLE PUTTING IT ON OAK CHAIR LEGS AND OAK TABLE LEGS. I PROBABLY DRILLED A SMALL STARTED HOLE BEFORE STARTING THE SCREW.
by|May 3, 2023
4 found this answer helpful
A: rounded head screw
by|May 5, 2023
Q:Are these glides good on 1 1/8 inch chair legs?
by|Sep 27, 2014
3 Answers
Answer This Question
A: They should be fine considering it is only 1/8" difference and the glides will cover almost the entire base of the chair leg. However, we cannot say for certain. You can try them out but if you experience any wobbling when you sit down then you should remove them.
Thank you.
by|Oct 27, 2023
A: THEY WOULD PROBABLY WORK FIND ALTHOUGHT THE LEGS I USED THEM ON WERE 1 INCH.