Customer Reviews for BrassCraft 3/8 in. Compression x 3/8 in. Compression x 20 in. Braided Polymer Dishwasher Supply Line

A super value and a high quality line. The Home Depot offers a great selection of supply line hoses for any application. I highly recommend this brand and it will provide long service.

Quality water supply lines that take the worry out of making plumbing connections. BrassCraft’s “3/8 in. Compression x 1/2 in. FIP x 20 in. Braided Polymer Faucet Connector (8-Pack)” are easy to install and well made. They feel like they’ll last a very long time with no risk of bursting. I’ve installed them before and never had a problem. This happens to be the “contractor 8-pack”, but they’re also sold individually and in other lengths. BrassCraft notes that Teflon tape is not required. I’m sure they’re right, and the product creates a water-tight seal, but I find that Teflon tape makes it easier to disconnect years down the road. This is especially true where hard water can cause the fittings to corrode together over time. It’s well worth it for the extra minute of time and few cents' worth of tape. Recommended. Model # B1-20A P8 Also sold individually as model # B1-20A F

These braided faucet connectors are great. I like the length and the fact that they came in a pack of eight. They are very easy to install and I haven't seen any leaks from them. Just be sure not to over tighten them. They are not too stiff so they are easy to maneuver while under a sink. I found that you could use them for the kitchen and the bathroom areas. They come in handy when you have connectors that are very old and need replacing.

The brass craft braided polymer faucet connector are really easy to install. If installed properly they will not leak like the pex tubes with the plastic ferrules. These are the standard size for installing on bathroom and kitchen sinks and the water cut off valve. They are easy to install with an adjustable wrench or the proper size open end wrench. No need to call a plumber.

The Brass Craft flexible faucet supply tube B1-20AP8, 8 pack is great! It is very convenient to use in order make both hot and cold-water connections between the water supply and sink faucet. It has a 20” flexible braided multi-filament polymer yarn supply line with one end has a screw-on 1/2” female compression washer connector for the faucet and the other end has a 3/8” screw-on female compression washer connector for the water supply. Inside the braided supply line, it has a tough PVC tube that is flexible and can bend freely without crimping or kinking and will not affect the flow of water. It is easy to use by hand tightening the screw connectors, then 1/4 turn with a wrench for a secure water-tight connection there is no need to use a thread sealant on the screw connections.

Perfect for when a dishwasher is located 1, 2 or possibly 3 cabinets away from the sink. In our case there are two cabinets located between the dishwasher and the sink and it was hooked up with two 4' compression hoses in series. When I had to do a repair on the dishwasher I noticed one of the hoses was not sealing properly at the end and rather than have the risk of a connection leaking inside a cabinet where it would not be detected I decided to replace the two hoses with a longer hose hopefully halving the risk of a leak. This was slightly longer than needed, but gave plenty of slack to pull the dishwasher out while still connected, which is handy if performing repairs.

every time i open the faucet the water tastes like brass leaving a bad taste

This standard product is consistently well-machined, easy to install and is a good value.

Fit perfectly and was easy to install

Very Good quality. Easy to install

Really bought the hose to get the rubber washers out of it. Couldn’t find the washers in the store anywhere sold by themselves. Fixed a small drip with the new rubber washer. No more drip! Thanks!

WELL MADE, PERFECT FOR THE PROJECT