A: This is not a flocked foam. The foam is a high density, closed cell foam. Thanks,
by|Mar 6, 2024
Q:Can these be used with porch paint?
by|Jul 21, 2023
1 Answer
Answer This Question
A: Generally, these would not be recommended for this type of project. However, please refer to the liquid manufacturer's recommendations on the back of the can for further information. Thanks,
by|Jul 22, 2023
Q:What material is this foam?
by|Jan 24, 2023
1 Answer
Answer This Question
A: These rollers are made from a polyester-based closed cell foam. Thanks,
by|Jan 24, 2023
Q:Can this type of roll be use to apply polyurethane on plywood
by|Nov 16, 2022
1 Answer
Answer This Question
A: High quality brushes are always the preferred method of applying urethanes. Using a roller can cause the finish to bubble. Thanks,
by|Nov 17, 2022
Q:How can I avoid all the tiny air bubbles with this? Not getting a smooth finish.
by|Feb 5, 2022
1 Answer
Answer This Question
A: The two best ways to get the smoothest finish are 1) roll slowly and steadily. rolling too fast can create bubbles in the finish, and 2) don't over-roll. rolling back and forth to much will interfere with the leveling qualities of the paint and can cause bubbles as well as other problems with the finish. Thanks,
by|May 30, 2022
1 found this answer helpful
Q:Can you cut these in two down the middle, to make two 3" rollers? I.e., does the inner sleeve run all the way through the roller?
by|Jun 25, 2021
1 Answer
Answer This Question
A: The inner tube is plastic and runs all the way through. You can try to cut the 6" down to 3" using something like a hacksaw. Personally I would rather just purchase the 3" rollers. Hope this helps.
by|Jun 25, 2021
Q:Is the material in this high density foam roller permitted to come in contact with food and food surfaces?
by|Jun 21, 2021
1 Answer
Answer This Question
A: Sorry but these rollers are not certified for food and food surfaces. Thanks,
by|Jun 21, 2021
Q:How do you use this when you have an inside corner?
by|Aug 31, 2020
2 Answers
Answer This Question
A: I just use a 2 inch brush for corners. Hope this helps.
by|Aug 31, 2020
A: These mini rollers have a wrapped end opposite where the frame will be attached. When you load the roller cover with paint, make sure to also load the wrapped end. When painting inside corners, press that wrapped end of the roller cover into the corner to save from having to cut those areas in with a brush. Thanks,