A: Thank you. This can be used on dry wall with a stud and if using without a stud, we recommend the WingIt Stud-Less Installation Kit.
Internet # 202552917
Model # RC-RESGBW35-2
Store SKU # 1005557118
Store SO SKU #1000762707
by|May 20, 2024
Q:What is actual diameter of bar?
by|Feb 7, 2024
1 Answer
Answer This Question
A: Thank you. The bar is 1 1/4 inches.
by|Apr 4, 2024
1 found this answer helpful
Q:Does it work with fiberglass shower enclosures?
by|Jan 24, 2024
1 Answer
Answer This Question
A: Thank you. We do not recommend this be in a shower enclosure as there are some parts that can rust.
by|Apr 11, 2024
Q:Can it be installed with wingits grab bar
by|Jan 5, 2024
1 Answer
Answer This Question
A: Thank you. This can be installed with the WingIt kit.
by|Jan 8, 2024
Q:CAN THIS BE INSTALLED IN A SALTWATER POOL, IS IT ALL STAINLESS.
by|Mar 14, 2023
2 Answers
Answer This Question
A: Thank you. This cannot be used in a saltwater pool or where it will be contact with water.
by|Mar 15, 2023
A: I had this grab bar installed in my new shower. I do not know I about a pool but I imagine it would be safe, ask a pool store . I am sure they know for sure.Good Luck
by|Mar 21, 2023
Q:How can I locate studs behind a ceramic tile shower stall?
by|Feb 2, 2023
0 Answer
Answer This Question
Q:I installed two grab bars in a corner of a shower. They are so close that i cannot move one of the the stainless steel trim rings in to place because the grab bars are to close to each other in the corner to move one of the trim rings around the corner
by|Nov 19, 2022
1 Answer
Answer This Question
A: Don’t install both horizontal. The bar that would be at your side should be on an angle. And the one in front of you, horizontal. But more important, is having an assist bar on the vertical by the door. Because most people fall when they are getting in or out of the shower/tub.
by|Apr 17, 2024
2 found this answer helpful
Q:Is the 24 inch Galcer Bay grab bar compatible with Wingits?
by|Feb 23, 2022
4 Answers
Answer This Question
A: I don't see why not. The only possible issue is that the washer for the wingit could possibly extend beyond the edge of the flange. If that happens, you would not be able to put the escutcheon plate over the screw heads to hide them. I mounted my grab bar on a pine board, then mounted the board to the wall. This allowed me to go directly into wall studs with screws that went through the board. I didn't want to chance that the wallboard might not be able to support the weight of somebody grabbing the bar. I have photos, but I don't see a place to post them in this response.
by|Jan 7, 2024
2 found this answer helpful
A: Yes
by|Mar 11, 2023
A: Yes, the gentleman that installed our grab bars was impressed with them. Liked them better than the normal anchors. We use our grab bars multiple times a day and have had no issue with them pulling out of the wall.