A: This product, model 10038, is available at www.homedepot.com and is listed at $9.97 each.
Customer Care
by|Jun 30, 2022
Q:What is the depth or length or the teeth?
by|Nov 18, 2020
2 Answers
Answer This Question
A: you get about 2inches of depth to work with
by|May 28, 2023
1 found this answer helpful
A: Approximately 2 inches. The plastic is too flexible making it hard to use.
by|Dec 17, 2021
Q:How many tines/teeth does this have?
by|Jun 8, 2020
1 Answer
Answer This Question
A: There are 19 teeth per inch, 112 total.
by|Jan 3, 2022
1 found this answer helpful
Q:Where is it made?
by|Jun 4, 2020
2 Answers
Answer This Question
A: This is manufactured at our factory in China and distributed in the U.S. -Alexis, Customer Care
by|Aug 5, 2021
2 found this answer helpful
A: This is made in China.
by|Aug 5, 2021
1 found this answer helpful
Q:can two of them be connected to make it longer?
by|Jun 1, 2020
3 Answers
Answer This Question
A: Yes, you can link two of these gauges for longer contours. -Alexis, Customer Care
by|Jun 14, 2021
2 found this answer helpful
A: Yes you can. you have a gap between the two but yes they do connect together awkwardly.
by|Nov 24, 2022
A: no
by|Mar 5, 2021
Q:Do the pins lock in place after you have your design? Or do you have to be careful bringing in to the tracing material?
by|Jul 30, 2019
2 Answers
Answer This Question
A: No they don't lock. They move easily.
by|Jan 7, 2021
4 found this answer helpful
A: Thank you for your inquiry. The contour gauge will not "lock" into place however the tool easily forms and holds the shapes for a more precise template.
by|May 4, 2020
1 found this answer helpful
Q:None of these gauges seem to list a specification of the maximum depth it can adjust to. I bought one that looked very deep, but only could cover about 1.5" of depth change. I am contouring over a rock fireplace and easily have some 4" deep areas I need to profile, so the gauge needs to be able to cover that change in the distance the fingers move.
So how much will this gauge profile in depth?
by|Jul 26, 2019
2 Answers
Answer This Question
A: This will work. I used this for exactly the same thing while installing ceramic tile against stone.
by|Jul 30, 2019
A: Thank you for your inquiry. The gauge contour profile depth is 1.75"