Q:What size breakers or fuses do you need for it to run
by|Apr 29, 2024
1 Answer
Answer This Question
A: Hi and thank you for your question. The Recommended Over Current Protection Copper (fuse or circuit breaker amperage rating) is 25. The Wire Size AWG Based on N.E.C. Table 310-16 (75°C) is 10.
by|Apr 29, 2024
Q:These Marathon water heaters require a vaccume relief valve. How can a system that is constantly under pressure need this ? I can't fathom any reason there would be a vaccume placed on a water heater. Especially in a closed well system.
by|Apr 28, 2024
1 Answer
Answer This Question
A: Hi RonL and thank you for your question. Vacuum relief valves are used in water heater/tank applications to automatically allow air to enter into the piping system to prevent vacuum conditions that could siphon the water from the system and damage water heater/tank equipment.
by|Apr 29, 2024
Q:Will this water heat fit inside a 24 in pan? I know the specs say it’s 23.5 in wide, just wondering if it could fit inside the 24 inch pan.
by|Apr 8, 2024
1 Answer
Answer This Question
A: Hi Robert and thank you for your question. No.
by|Apr 9, 2024
Q:Do I need the expansion tank?
by|Mar 23, 2024
1 Answer
Answer This Question
A: Hi James, a thermal expansion tank would depend on what your incoming cold water pressure is. We recommend reaching out to a plumber to assist you with getting a water pressure reading and obtaining a thermal expansion tank if necessary.
by|Mar 24, 2024
Q:Can I change the P&R valve on this if it starts leaking?
by|Mar 17, 2024
1 Answer
Answer This Question
A: Blake, Thank you for your question. Yes the valve can be replaced.
by|Mar 18, 2024
Q:Is this unit supposed to come w the hot/cold fittings that connect to the female inlets on the water heater?
by|Feb 16, 2024
1 Answer
Answer This Question
A: Hi RoseAnne and thank you for your question. The hot water connection is provided with a ¾” or 1” connection depending on the size of the unit. The cold water connection and the temperature and pressure relief valve are supplied with ¾” NPT connections.
by|Feb 19, 2024
Q:What are the specific connections for hot & cold lines? Male or female?
by|Jan 31, 2024
1 Answer
Answer This Question
A: Ryan, Thank you for your question. The water heater would be female input and the fittings would be male.
by|Jan 31, 2024
Q:Would this water heater be compatible with a water softener unit?
by|Jan 30, 2024
1 Answer
Answer This Question
A: Nick, Thank you for your question. There would be no problem using a water softener.