Questions and Answers for Simpson Strong-Tie LPC ZMAX Galvanized Adjustable Post Cap for 6x Nominal Lumber

A:  Hello Kkrc, my name is Colin with Simpson Strong-Tie. Please accept our apologies for this delayed response. The two-piece LPC6Z post to beam cap was tested with 0.148"x3" (10d) nails into the post and beam. You cannot substitute 0.148"x1-1/2" (N10d) nails or any other fastener and still achieve our published allowable load values. If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you.​​

A:  ​Hi Newbie2this, thank you for your message. This is McKenzie from Simpson Strongtie. We want to make sure we address your question regarding the LPC6Z. To better assist you, please contact our Customer Service team at 800-999-5099. We look forward to hearing from you. Thanks.

A:  Hi Bobby, this is Colin from Simpson Strong-Tie. The required nail for the LPC6Z is a 10d common (.148" x 3"). If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. Thank you.

A:  Hello Stannius, this is Stacy with Simpson Strong-Tie. Yes, the LPCZ is designed for a variety of connections between a 4x or 6x beam and a post. This versatile, light post cap has an adjustable design that allows for connection versatility in both new and retrofit applications where structural support is needed. If you have any questions please call us at (800) 999-5099. We look forward to speaking with you.

A:  Hi Carl, this is Colin with Simpson Strong-Tie. The LPC6Z is sized for a 6x6 post and can accommodate a beam up to 5 1/2" wide (which includes a triple 2x12). If you need more information or have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you. Thank you.

A:  Yes most definitely. Very versatile bracket. Use two per post, one turned in against one, two, or three 2 bys and another on the other side. The “extra” inch can be on the inside, outside, or split the difference with a half inch on each side.

A:  Yes, I used them to do this with 3 2x8s when building a patio shelter.

A:  ​Hello Horatius, this is McKenzie from Simpson Strong-Tie. Depending on your load requirements, an ECC or ECCQ may be an option. More information on these products can be found here: https://www.strongtie.com/search/?q=end+column+cap. If you have additional questions, please contact the Simpson Strong-Tie Customer Service team at 800-999-5099. We look forward to hearing from you.​​

A:  ​Hi mang, this is Colin from Simpson Strong-Tie. At our home page strongtie.com, enter LPC in the Search Strong-Tie box. Click on the LPCZ Light Post Cap result. The allowable load values for the LPC4Z post cap installed in pairs are listed including the required fasteners and installation instructions. The seat of each cap is 1-1/4" so they can be installed 3" apart for the double 2x10 beam(s) on top of a 4x4 post. And note: Uplift loads do not apply to spliced conditions. spliced conditions must be detailed by the Designer to transfer tension loads between spliced members by means other than the post cap.

A:  Hello, LPC6Z connector is manufactured from 16 gauge steel which is about 1/16" thick. Regards.