Questions and Answers for Tapcon 5/32 in. x 5-1/2 in. Carbide Masonry Drill Bit

A:  Hi CeeCee - Thank you for reaching out! For application specific questions, please reach out directly to our customer service team at 877-489-2726.

A:  Yes that’s what I use. 

A:  These items worked on a paver stone stair case when installing a railing. I would think it would work on natural stone as well.  

A:  Hello - Thanks for reaching out! You can use a 5/16" Tapcon+ Concrete Anchor.

A:  Sounds like you are not using a hammer drill.  A hammer drill will make it last much longer, otherwise the heat will dull it faster

A:  Yes. I used a DeWalt drill and drilled into cinder block. No problems.

A:  yes

A:  Tapcon drill bits come with 2 different shanks. One has plain round sides that will work on a drill that has a Jacobs chuck, which has three jaws and fits round & hex shaped bits & drivers. The other has 4-sided shank, for only a quick-disconnect chuck.

A:  Yes. Have used them for years with my standard DeWalt drill/driver

A:  Yes

A:  Yes, most of the drill bit works with standard drill.

A:  Yes you can drill into a 2x4 with this bit, but your best choice would be a standard wood bit as this is a masonry bit for concrete, brick, etc. The wood bit will also give you cleaner drilled hole.

A:  Great for securing wood to concrete.

A:  The best out there!!

A:  No, you can not because this drill bit is for concrete only used in a hammer drill !!

A:  I didn’t measure the drill but itself, but it worked perfectly with the recommended Tapcon fasteners.

A:  I’m not sure but the only time i’ve had these screws not hold is when I over-tighten them.

A:  Fits in