Customer Reviews for Avanti 7-1/4 in. x 60-Tooth Carbide Fine Finish Circular Saw Blade

the blade cut clean and quickly through the solid core door I was installing a dog door in.

I used this to cut down some hollow core doors that were too long. Hollow core doors are made with a very thin and fragile outer skin. I was concerned that when I cut it, the skin with peel or crack. However the blade worked fine with no cracking peeling.

Cuts a very accurate close cut for those interested in tight joints. Very pleased. Worked great on my 20+ year old saw.

Great for smooth cuts!

I wanted this blade to cut off just 1/2 inch from a couple of doors so the carpet could fit. It did an excellent job. It isn't stamped "carbide tip" on the blade but you can see it is. Looking forward to many more uses. Recommended.

This saw blade was used to cut a wooden bed foot board and head board. Cut it perfect with no splinters or marks to the finish.

Good smooth cut. Great for miter work.

Nice smooth cut on oak. Excellent

The blade was perfect for the job of trimming down a table.

I used this blade to make some small, hardwood parts on a tablesaw. The cuts were veryaccurate and smooth. This is a inexpensive but high quality blade. For my purpose, it did an excellent job.

very smooth blade

Best saw blade I've ever used. Beautiful on MDF and Brickmould.

I purchased this blade to replace the original blade for my Ryobi circular saw, and I must saw it cuts through wood like butter. I'm a DIY homeowner learning as I go, but I have zero complaints regarding this blade.

Sure beats my 12 year old burnt and chipped combo blade.

Works as intended.

This blade cut beautifully and cleanly through a formica countertop. A very good value.

Blade worked great on my wood door. Was reasonably priced. Would buy this brand again.

bought this product just last week. It does what I am asking it to do. It has cut the 1/2" PLYWOOD AND 1/4" MDF very well.

I thought it would do fine on finish cut but was not what I expected

My miter saw included a different blade which shattered the small boards I tried to cut. This 60-teeth blade was easy to install and easily cut the small boards perfectly.

good blade for cutting without chipouts on the wood.

Failed to cut treated 2x6 board

Blade worked well for cutting luxury vinyl plank flooring. Carbide teeth were the key, as a regular blade will be quickly dulled by the resins and glues that are surprisingly hard in the flooring. I tried a 140tooth finishing blade and it bogged down towards the end, but this was more durable.

I used this blade to dress 30' of raw mahogany. It worked very well, with clean cuts and no binding. A good high-tooth saw for the money.

The cutting was fine and didn't leave a rough edge fine but the run out was about 2.5 times the blade width.

Superb!!!

very satisfied with product

Good value for the price. My small job did not need such a smooth cut, but the blade fit my skillsaw and my desire for precision. For furniture and moldings, I use a 10 inch table saw.

Cut well!

Fine cutting blade at a reasonable price; couldn't be better than that! Works better than expected.