Customer Reviews for Hillman 3/16 in. Pull Toggle (12-Pack)

The plastic part can be hard to break off. Hard to fully seat the round ring. Screw doesn't easily engage the metal piece behind the wall causing it to stick or rotate and fall down .

Crapy design with one zip pull.

Point the "arrow end" up as/after you insert in the wall and make sure you can actually see the hole for the screw clearly before you pull the plastic strap tight and break it off. Otherwise, sometimes the paper on the back side of drywall could wind up blocking your attempt to seat the screw during the mounting process. Just take a bit of time and watch what you're doing and they'll work great.

As a contractor, field reliability in a product is critical. I came across this product in 3/8" & 1/4" only to discover how genius this product really is. The solid body anchor holds fast in any mounting use, solid or wallboard, and does NOT cut into the rear side of wall board weakening the anchoring. As a contracting company, we moved away from Walldriller brand self-drilling plastic anchors and now use only the Hillerman Pull Toggle as our "Go To" for all heavy mounting needs.

Out of the twelve pack I was able to use eight pieces. Four pieces broke at the toggle as they were being inserted into the hole drilled in the wall. Plastic strips seem brittle.

Garbage, doesn't work, overpriced waste of money.

These are the best anchors I’ve ever used !

Hated them. I broke 5 of them before I finally got one to thread. Poor design

Most of them will fail before you get the screw tightened, and then end up in your wall. Save some time by throwing the box in the trash and cuss a lot, then go buy something else. The zip-tie anchor is very weak and a bad design.

Fast and easy to use

These toggles are great, easy to use and very strong. I used them to help support a wall mounted TV because there were only metal studs in the wall. Worked very well

Work much better than the original snap toggles. I have not lost one of the threaded anchors in the wall yet with these as opposed to the snap toggles.

I had a couple of these fall apart as I put them into the wall...

Because they are designed with only one pull, the toggle breaks off and falls into the interior of the wall. I just returned the rest of the product And went to Lowe’s to buy toggles with two pulls that work better.

Works like a charm. Follow instructions. Used to hang heavy drapes in 1/2” Sheetrock.

Worked well: easy to use

Much better then than the other brand Home Depot sells.

Mounted shelf with no studs, feels very solid, compared to other anchors.

A couple of them snapped during installation. I won’t buy them again.

They work a lot better then the other brand of similar product that Home Depot carries.

by far the easist to work with, well constructed and always works. Outstanding!

Hard to use. Really didn't meet expectations.

These were pieces of junk. They kept breaking and did not perform as the directions indicated. I purchased a package of 10 and I think I only had one work properly.

Works like it supposed to which is great

Did not work the way it was demonstrated. Had to go with Normal toggles.

1/3 of the toggles broke during install and had to be replaced.

Rating provided by a verified purchaser