#1 Home Improvement Retailer

Customer Reviews for J-B Weld KwikWeld 0.1 oz. Epoxy Syringe

Internet #303710806

Model #50176H

Store SKU #1002913062

  • Easy-to-use syringe with re-sealable no waste cap
  • Quick-setting steel reinforced epoxy
  • Sets in a matter of minutes and cures in 4-6 hours to dark grey

Customer Reviews

  • 4.3
    out of 592 reviews
  • 83% recommend this product
Filter by:
Showing 1-30 of 592 reviews
JB Weld is always dependable if you select the proper one for the job.
by
  • Verified Purchase
This held metal and wood together well.
by
  • Verified Purchase
Wasn't sure that this would repair our stove top grate, but was so happy it worked. Loved how easy to use and that it seems to be holding up to the gas stove temperatures. Two part epoxy sometimes doesn't mix easily, therefore does not create a good "weld",and sometimes creates a mess. This dingle plunger delivery system made it easy to get the right mix. Very happy with this purchase.
by
  • Verified Purchase
by
  • Verified Purchase
by
  • Verified Purchase
This stuff works!! I used it on a radio antenna that had broken off at the base. I did not think it would work but it did. The part is as strong as advertised.
by
  • Verified Purchase
by
  • Verified Purchase
It is very easy to use. Just squirt a little in the plastic tray, mix until it it is grey and then apply. You must be quick because it starts setting within 6 minutes. The problem I had was I needed it to work in a higher pressure (household water pressure) and on heat up to 135 degrees. It didn't stop the leak and after several heat cycles I could easily peel it off with a screw driver. The surface was wire brushed and cleaned prior to application.
by
  • Verified Purchase
by
  • Verified Purchase
jb wled amazing
Eli was of great service and help i hope he is taken care of well because customer service like that is hard to find
by
    • Recommended
    by
    • Verified Purchase
    by
    • Verified Purchase
    by
    • Verified Purchase
    by
    • Verified Purchase
    by
    • Verified Purchase
    by
    • Verified Purchase
    Good product as expected, strong and leak proof.
    by
    • Verified Purchase
    Strong bond to repair RC racing sail boat. Fast and permanent repair.
    by
    • Verified Purchase
    by
    • Verified Purchase
    I used K-B Weld to repair a pin hole on an indirect water heater recently. Fortunately the hole was on the low pressure side and the job weld bonded surprisingly well to seal the hole giving me time to find a replacement tank. Great product!
    by
    • Verified Purchase
    by
    • Verified Purchase
    by
    • Verified Purchase
    Don't Waste Your Money
    I purchased this product hoping it would be easier to use since it's supposed to squeeze out the same amount on both size and had a locking cap. It DOESN'T squeeze out the same amount on each one. You have to play with the plunger on each side to get the same amount out. The cap literally sucks! The locking mechanism needs to be redesigned. It's so hard to get the cap on and off. I won't be buying this again. I will buy separate tubes next time. The ONLY good about the product is, it does work!
    by
      by
        by
          by
          • Verified Purchase
          Very good product efficient
          by
          • Verified Purchase
          by
          • Verified Purchase
          by
          • Verified Purchase
          Excellent!!! Sticks like an old girlfriend that you have dismissed from your life!!
          by
          • Verified Purchase
          Showing 1-30 of 592 reviews

          Frequently Bought Together

          Top Rated
          +
          +
          Price: